So, with this feature the "Locate Profile" isn´t used anymore? I mean, at the beginning of the video, I understood that that surface will be upon the weldment system, as usually in a sheet metal cover but not, all the frames are in the middle of the surface. Anyway, Thanks for sharing!
When using the Structure System command, the settings you mentioned can be made with the "Pierce Point" options in the profile tab on the left panel. I am sharing the help document on the subject below. I did not go into these details too much so that the video does not get too long. help.solidworks.com/2021/english/solidworks/sldworks/c_Weldments_Pierce_Points.htm
So, with this feature the "Locate Profile" isn´t used anymore? I mean, at the beginning of the video, I understood that that surface will be upon the weldment system, as usually in a sheet metal cover but not, all the frames are in the middle of the surface. Anyway, Thanks for sharing!
When using the Structure System command, the settings you mentioned can be made with the "Pierce Point" options in the profile tab on the left panel. I am sharing the help document on the subject below.
I did not go into these details too much so that the video does not get too long.
help.solidworks.com/2021/english/solidworks/sldworks/c_Weldments_Pierce_Points.htm
which is solidworks version
I think this feature came in SW2019 version. This video was created with SW2021.