Wirtgen 210 level pro

[@robjohns5806]

Thank you, been on ground on 210 for a couple years. Much rather mill than pave and people like you saved my ass when starting out

[@jaysonboyer7143]

Very helpful and pretty much spot on. Dont forget to match up your numbers (holding top grey w lower white buttons will auto match in about 1.5 seconds)
Before switching from side plate to front scanner. Also switching to cross slope, must match your slope numbers before switching to slope, also by holding upper grey and lower white....... matched boom, then switch

[@pm565b2]

Thanks, been out of milling for three years and going back to it this season. This has been helpful.

[@heliorochasantos7911]

Parabéns o vídeo ficou muito bom tirei todas as minhas dúvidas a pesar de não falar outra língua.

[@miguelf1699]

Could you make a video showing up ...setting up slope, grade,radiante and starting to grind then setting up in automatic....it seems you got lots experience...tx

[@heavyequipmentchannel7936]

thanks for good video about level pro,,,’

[@rubenmontealegre6158]

Traduccion?

[@civilengineersshahzad2156]

Very nice

[@lancenelson5952]

Is the machine up in the air when you’re zeroing it out? And do you have to have brand new teeth in order to do this?

[@daghanam]

Great video , can you please make video for slope setting ? Thank you pal

[@alexandermorillomorillo3591]

Es español traduselo

[@caseyklein5169]

Make a video for slope please 🙏🏼

[@CRF150RacingChic]

I need a video for ground for beginners please

[@richardchilds7476]

Anyone know how to zero out the ACT values on the Wirtgen slope sensor?

[@artabanplascencia216]

Good video! I got a problem with level pro, hope someone could help me, how can I switch from cm to inch? Thx a lot

[@MedOgad-xb2gz]

Wertgen 100

[@eduardmedina3330]

Necesito traducción por favor en español

[@MedOgad-xb2gz]

Wirtegen w 100 f

[@enockacquaah4499]

Hello please I need help, can contact you outside this site