QUICK TIP: THE BEST LIQUID GASKET MAKER THAT I HAVE EVER USED!

Поділитися
Вставка
  • Опубліковано 15 січ 2025

КОМЕНТАРІ • 10

  • @CravinMorehead420
    @CravinMorehead420 9 місяців тому +2

    Used to use Ultra Black RTV. Changed it up, have had no issues with it..

  • @rkj6969
    @rkj6969 4 місяці тому +2

    Very good. Very believable, and love that you do not play music. Good job!

  • @dharley189
    @dharley189 9 місяців тому +2

    Good advise. I worked at Subaru 14 years. Used Fujibond a lot and had a ton of dried up tubes.

    • @TheEnthusiastMechanic
      @TheEnthusiastMechanic  9 місяців тому

      I used to work at Subaru and I do remember it would be common to get dried/hardened tubes or if you didn’t seal the opening of the tube right after using it it would harden everything. I will say, though I was able to glue an oil pan to a wall and hang off of it using FujiBond that stuff is serious when it comes to sticking on if you prep correctly!

  • @wcjcnc
    @wcjcnc 2 місяці тому +1

    I have a small engine repair shop. I’ve used every gasket maker you can get. The Right Stuff black is the only one I use now.

    • @TheEnthusiastMechanic
      @TheEnthusiastMechanic  2 місяці тому

      I went through a similar thing I tested so many of them to come to find this and stick with it.

  • @lothegreat1788
    @lothegreat1788 2 місяці тому +1

    What about for water pump and thermostat?

    • @TheEnthusiastMechanic
      @TheEnthusiastMechanic  2 місяці тому +1

      @@lothegreat1788 I personally haven’t used it for that because most water pumps nowadays have a gasket, but I believe it should work as long as the area is stick on is cleaned and prepped and dried

    • @lothegreat1788
      @lothegreat1788 2 місяці тому

      @@TheEnthusiastMechanic I’ve seen a few videos of people who have but also know they make a gasket specifically for it. The wait time is 24 hours and inconvenient so I was curious if you had any experience using the quicker versions on either