there is no feed rate oin edm, the speed of the tool is determined by how well the cutting is. more important; than this question, underneath you dont know the edm motion is a chacha dance, usually forward , odten backward but just 1 step or two. A very good cut is usually foward along the programmed path. look uo 'stachostic', thats hwat EDN is
Hello, I sthis the same company I bought EDM generator from years ago>? Ir was a 'hot' generator, not isolated from mains. I am interested in what you have to offer.TomP
Good work. You many features that most DIY WEDM dont have. I did not see where you set the target volatge ( I suspect your control system tries to amintain a given gap volatge. Good on you! Thanks
very COOL
Home made??? all that big machine is home made???? Guauuu!!! very impresive!
Abiciğim eline sağlık
Very cool! How did you determine feed rates for XY?
Hello, Nelson. Which schematic for a spark generator did you use? Can you share?
there is no feed rate oin edm, the speed of the tool is determined by how well the cutting is. more important; than this question, underneath you dont know the edm motion is a chacha dance, usually forward , odten backward but just 1 step or two.
A very good cut is usually foward along the programmed path. look uo 'stachostic', thats hwat EDN is
Hola, que tipo de motores tiene y que servos. Felicitaciones
Hello, I sthis the same company I bought EDM generator from years ago>? Ir was a 'hot' generator, not isolated from mains. I am interested in what you have to offer.TomP
Good work. You many features that most DIY WEDM dont have. I did not see where you set the target volatge ( I suspect your control system tries to amintain a given gap volatge. Good on you! Thanks
Hello sir can you share more details about circuit and all components used
I think he built generator and servo, I see 'arduino; on panel. The mcahine tool is a sued machine, not home built, just home modified
Здравствуйте. Можете поделится схомой станка?
Slm.Abi bana güçkaynağı lazım .yardımcı olabilirmisin.Teşekkür.
¿Como evitas que el hilo se corte por cortocircuito?
The wire doesn't touch the piece. The spark in the dieletric middle removes material from piece.
El hilo no se corta tiene un circuito con un ML358 que detecta el corto circuito y la máquina da reversa
could you share the schematics of your spark generation system?
Estoy utilizando un circuito RC
With 20+ capacitors I would think the feedrate would be a little higher.
The probability of spark is not high enough.