Transmission line Fault detection Using Arduino with IOT

(Whatsapp link)
wa.me/91965524...
This project deals with new method of single phase fault detection technique is used, along with automatic switching based on an Arduino display of the issue. Our detection method focuses on current that travels through cables. There will be a maximum current capacity for each cable. Current immediately increases when a short circuit fault happens. Current will be zero in an open circuit as well. Current transformers are used to measure current levels; the output current is then sent through an I to V converter unit to convert it to voltage readings. The Arduino's ADC pin receives this voltage and converts it to digital information. If any fault conditions (SC or OC) arise, the ADC pin will then take the required action. This error is shown on both an LCD and an LED display To ensure an uninterrupted power supply for end users, the municipal electrical distribution system's single phase load is switched to the other good phase using a relay driver and relay circuit. A switch for manually notifying the system of fault clearing is available. After that, just the load will be converted to regular phase. The GSM module was used to convey information to the appropriate authorities.
FOR MORE DETALS
INNOVOTRONICS
Sudhakar Nagar,
(opp Crompton service center)
Villupuram, Tamil Nadu 605602
Cell : 96552 44999
INSTA ID:
www.instagram....
FB ID:
www.facebook.c...
Location: goo.gl/maps/yZ...