Beautiful video I have canbus in my a3 2009 and i don't want to connect it with the reverse lamp because when i brake the video start distorted I see you didn't connect it with the reverse lamp can you explain why please?
I had a similar problem when the car was off the camera worked fine, but when i turned the car on no signal, then i connected the red and black wires to the wiper motor and now works fine.
Salut. Nu stiu. Scoate navigatia si vezi pe eticheta daca are vreo mufa pentru camera. Ar trebui sa aiba pentru ca navigatia a fost montata si pe modele de audi cu camera pe spate.
I do not know how to call it, but it looks like fishing wire and is used by electricians for pulling wires throw the walls. I bought it from a bricolage store. Try at electrical store. Read my webpage, link in video. Maybe it helps.
Im having difficulty trying to install my camera. I have navigation with canbus. From one side I connected the red cable to navigation to"reverse" but what happens to the other side (camera side)? where do we connect the red cable? do we just leave it hanging? Again one side is clear, the other where the camera is i dont know what to do with the red cable
Red wire is for power the camera. If you connected to navi, the other side of the wire need to be isolated. If you do not have navi, you can power the camera to the rear reverse light. So, in your case, you power the camera from the navi, you do not need to power it from the reverse light. Isolate the other side.
I was trying the installation for my self but damaged the rubber sleeve that the wires are ran through in the upper trunk area. Is it OK to leave the rubber seal loose or is it important to have the seal back in its original state?
In cazul meu, cablul video are cate un fir roșu la fiecare capăt. Cele doua fire rosii sunt pentru alimentarea camerei, și se folosește doar unul din ele. În cazul meu, am navigatie, și din navigație îmi ieșea un fir dedicat pentru a lega de firul rosu si astfel sa alimentez camera. Daca nu ai navigatie, poti alimenta prin firul rosu de la capatul dinspre camera, și ar trebui legat la becul de marsarier.
My head unit is an android with navigation system but I don't have the canbus installed. In this case, do I have to connect the red and black to the reverse lights or will still work connecting the reverse cable to the reverse from the head unit?
Salut am o intrebare daca ma poti ajuta eu am un a4 b7 si vroiam sa pun scaune de a4 b7 sline care sunt electrice crezi ca vor merge fara sa fac modificari ms mult
Hi, did you need to put the other red wire to a live? And did you ground it? I tried just putting the red wire on the reverse wire but it didn't work... how can i isolate the other side? Any help is appreciated, thanks 😊
I use this rear camera with chinese navigation. The red wire is "+". The ground is on the video cable. The video cable is made of two wires: one is inside, for video signal, and the other one is around the first one and is for ground. My english is poor and is very hard for me to explain. Both red wires are for "+" and you can use one. No need to connect both. In my video, the ground is from RCA connector from navi.
Maybe a stupid question but the long white cable you use i see it not in the beginning do it came with the package or why you choose for that wire thanks im waiting my system to arive this week
There are 2 red cables. One red cable on each end of the harness. If you have android navigation, you connect the red cable to navi, but if you don't have navi, you connect the other red cable from the trunk lid to rear white light. The red cable is powering the camera when you drive back.
I did not connect the red and black wires. I have navigation head unit, so I do not need the red and black wires. Navigation is powering the rear camera.
Beautiful video
I have canbus in my a3 2009 and i don't want to connect it with the reverse lamp because when i brake the video start distorted
I see you didn't connect it with the reverse lamp can you explain why please?
I had a similar problem when the car was off the camera worked fine, but when i turned the car on no signal, then i connected the red and black wires to the wiper motor and now works fine.
Salut ss poate instala si pr navigatia originala?
Salut. Nu stiu. Scoate navigatia si vezi pe eticheta daca are vreo mufa pentru camera. Ar trebui sa aiba pentru ca navigatia a fost montata si pe modele de audi cu camera pe spate.
If reverse camera+parking sensors kit is mounted, do I need to connect 12V from reverse light or is canbus enabled?
In my case, is canbus enabled by navigation. In your case, you will probably connect to reverse lights.
Syper bravo!🙂
Great video its been very helpfull with my A3. Thank you for posting. 😊👍👍
Follow the link in description. You will find more interesting things.
What product do you use for threading the cables? Where can I buy it? Thanks!
I do not know how to call it, but it looks like fishing wire and is used by electricians for pulling wires throw the walls. I bought it from a bricolage store. Try at electrical store. Read my webpage, link in video. Maybe it helps.
I looked it up with the info you gave me and apparently it’s called electricians tape or a wire noodler! Weird!
What about Vision in night? This kamera dont have a addictional diods or IR lights
For night, camera switch itself to black and white. Rear lights are enought. Don't need IR leds.
@@nichiforiuc Thanks for you answer :)
Im having difficulty trying to install my camera. I have navigation with canbus. From one side I connected the red cable to navigation to"reverse" but what happens to the other side (camera side)? where do we connect the red cable? do we just leave it hanging? Again one side is clear, the other where the camera is i dont know what to do with the red cable
Red wire is for power the camera. If you connected to navi, the other side of the wire need to be isolated. If you do not have navi, you can power the camera to the rear reverse light. So, in your case, you power the camera from the navi, you do not need to power it from the reverse light. Isolate the other side.
Is this easier than letting the wire carry on down passenger side and under glove box?
I believe is shorter.
Hi , i have one Question , i do not have parking Sensor where i have to connect the red cable ! Thank you
I just decided to give my am away. What a job
I was trying the installation for my self but damaged the rubber sleeve that the wires are ran through in the upper trunk area. Is it OK to leave the rubber seal loose or is it important to have the seal back in its original state?
you prob solved it but, no problem if u damage them but it would be a good idea to change it with new ones later one
Salut Bogdan, imi poti spune te rog pentru Audi A3 8p cum ma conectez la plusul pentru masalier ca sa dau semnal la camera.Multumesc
In cazul meu, cablul video are cate un fir roșu la fiecare capăt. Cele doua fire rosii sunt pentru alimentarea camerei, și se folosește doar unul din ele. În cazul meu, am navigatie, și din navigație îmi ieșea un fir dedicat pentru a lega de firul rosu si astfel sa alimentez camera. Daca nu ai navigatie, poti alimenta prin firul rosu de la capatul dinspre camera, și ar trebui legat la becul de marsarier.
Vezi si pe site-ul meu, poate te ajuta vreo informație de acolo. Estre trecut și în video, și în bio.
How is your camera settings on your Radio? Which camera type?
I choose a wide camera, no setting needed. Plug and play.
170 degree lens
My head unit is an android with navigation system but I don't have the canbus installed. In this case, do I have to connect the red and black to the reverse lights or will still work connecting the reverse cable to the reverse from the head unit?
Yes
Salut am o intrebare daca ma poti ajuta eu am un a4 b7 si vroiam sa pun scaune de a4 b7 sline care sunt electrice crezi ca vor merge fara sa fac modificari ms mult
Nu stiu. Nu am incercat. Sigur o sa iti trebuiasca codare vcds.
How can you pull cable out of reverse lamp connector wire to add the extension wire?
I didn't connect that wire to re erse lamp. I connected it to navigation.
Hi bodgan. Can you provide link for camera and other parts you purchased for this retrofit? It will be very helpful.
Search for rearview camera on ebay. There are many cameras.
Hi, did you need to put the other red wire to a live? And did you ground it? I tried just putting the red wire on the reverse wire but it didn't work... how can i isolate the other side? Any help is appreciated, thanks 😊
I use this rear camera with chinese navigation. The red wire is "+". The ground is on the video cable. The video cable is made of two wires: one is inside, for video signal, and the other one is around the first one and is for ground. My english is poor and is very hard for me to explain. Both red wires are for "+" and you can use one. No need to connect both. In my video, the ground is from RCA connector from navi.
@@nichiforiuc Did you need programming before installing the camera on the Chinese radio? Or just need it on the original radio
Hi, you have no Signal/ bad picture or we see that so on your radio?
Esagerato dai
Thanks, buddy! Very helpful!
Where do you power the camera? And also reverse signal for head unit ?
Red wire minute 17:40.
The head unit takes the reverse signal from Can-Bus.
@@nichiforiuc so the cam switch on using the wire for reverse triggering , it means no others wire need to be connected to 12v line, that is correct ?
Yes. No other wire. As in the video.
Maybe a stupid question but the long white cable you use i see it not in the beginning do it came with the package or why you choose for that wire thanks im waiting my system to arive this week
😱
Hi, can you explain me how to pass the cable from the rear seats to the rear tunnel? Thanks
Under the carpet, use a hard wire.
come si potrebbe acquistare??
ovviamente tutto lo stereo
Buenas el cable rojo a donde va conectado
There are 2 red cables. One red cable on each end of the harness. If you have android navigation, you connect the red cable to navi, but if you don't have navi, you connect the other red cable from the trunk lid to rear white light. The red cable is powering the camera when you drive back.
Hola el cable de atrás el rojo y negro, ese donde lo conectas?
I did not connect the red and black wires. I have navigation head unit, so I do not need the red and black wires. Navigation is powering the rear camera.
Excelent !! Multumim
In weekend fac si review pt navigatie.
@@nichiforiuc Abia astept!
very good job
Thx. Follow the link in description for more infos.