Best of luck to you.... if you heard what I said in the video... it was a temp code I made for the purposes of the video. The code has since been deleted and will not be back on until I decide to make another video. 🤣🤣
If alarm is off snd door or is open or broken will it just make the chime door open and not do anything else or what also if you have camera setup how far can it look back to see if anything has happen
No cameras at this time.... if the system is armed and someone breaks a window... the alarm will go off at the same sound as you heard here in this video... if its in Armed Away and the front door is open.. it will start beeping and gives you 30 seconds to disarm before it goes into a Alarm state and it goes off .. .. if you have it In Armmed Away and you open the back door.. it would go into immediate alarm state as the back door is not a bypass door while in Armed Away.... now if i go to Armed Stay... both doors will be bypass doors because I used Armed Stay when i am home so it will give me time to disarm before the alarm goes off.
The siren is loud via the panel. It’s the same sound you heard in the video.... it may not sound loud here but trust me it’s loud enough if you in the house... no to loud that you can hear it very well Outside the house unless your close.. but this was the same amount of loudness as my older system was.... as for extra sirens... I am not for sure. I am sure ADT might have said equipment but I have never had a need to get one.
That long beep noise is the siren? Really? The system I had growing up would make that extended “beeeeeeeeeeep” noise for 45 seconds and after that if the code wasn’t entered, a very loud siren would blare until the alarm is disarmed. Sort of disappointing that ADT doesn’t have something like that to actually scare off intruders. A “beeeeeeeeeeeeeeep” noise/sound isn’t going to do much.
@@adamhoeg1311 the ones you see in movies with home invasion Intruders. Alarm going off sound. The beeeeepp is lame need more settings for sound options.
I don’t use the panel anymore but it will under your settings… probably in advance settings where you need to enter your code… i know it’s easy to find… Editing my comment… mainly because I rushed to answer after seeing the notification without reading the whole message.
After taxes it’s like $70 a month... it works just fine for me however I do have older units around my house for my doors and glass breakage so I get issues 2-3 times a week of my old devices falling out of syncs for a few minutes which causes a warning alarm that I have to acknowledge for it to stop... this warning alarm I am talking about will not cause ADT to contact me... it will just beep continuously until I clear it..... I think upgrading the other devices I have will fix this issue... (I use to have an older control panel and I only upgraded to this new one because my wireless adapter on my old panel was about to be disabled by AT&T which is the carrier for the wireless signal... so an upgrade and a new 3 year contract was mandatory)
Heck yeah! It was $59 for 1 camera and the keypad. I needed an extra camera so it’s $70 with a little keychain pad monthly! Over $1,000 for the whole setup. 2 cameras and the wall mounted system
You can blame ADT for that! Now I don’t have ADT anymore but my mom has it at her cleaners business and hers actually does not do that anymore so from what I know.. they actually fixed it
Test mode puts it in a safe state for all alarms that goes off.. this includes the fire and medical... in fact it something they recommend testing each month to make sure it is operating properly outside of its own self checks... To put it in test mode. You have to go go your Account on the MyADT side and put it in test mode there.. when you do.. they will ask for a time limit.. and you all set.. just be sure that if you finish before the time limit you set to go back and take it out of test. Also when you test.. you need to test to make sure ADT recieves the signal on their end by using the Logs (on the MYADT site or on the app) the panel sends which will happen even when it is in test mode.. but don't worry even though ADT systems will still get the signals.. they will not contact you as long as you have the account in Test mode.
@@rztndiii hmm let me think on it. If i do anything it will be here.. i might simulate a break in or something and record it all for people to know what happens or something
So i never got an email on your comments here so i just now seen them.. sorry for the delay. The Tech when he first installed it after i asked said there is a screw at the bottom you have to take out. After you do so it should easily pop off.
@@gregdiprinzio9280 and what proof do you have that they are spying on you????? You have no proof that’s why your conspiracy does not have any weight on it
@@sevokevo There's a camera and microphone on the command module. There's a (probably bored, sexually deviant, accustomed to invasion of privacy) human being (with no morality and a "keeping you safe" rationale) with access to them. What could go wrong?
@@gregdiprinzio9280 that does not prove a damn thing! Front camera is used when someone fails to disarm the panel and I get the pic from my app… the mic is used to record from it… not to mention that it also use to have Alexa intergraded into the system but not any more… but still that does not give you ANY EVIDENCE that they are doing as you said so enough with your trolling conspiracy BS!
What happens if I turn on alarm for away and my door gets open and I don’t disable the alarm what will happen after that will cops come or will the alarm just keep going till I stop it?
If your door gets open.. it will give yoi 45 seconds to disarm the system before the alarm goes off... after which if the alarm is not disarmed within 15-30 additional seconds.. then ADT will contact me to acknowledge the alarm and see if everything is alright.. and will also ask for my special word i have setup to know its me or not... if i am not home when this happena and i acknowledge i am not home. They will contact the local police.... if the alarm calls and i don't answer the phone when they call. They will contact the local police then contact my family and let them know that my alarm has gone off and have been unable to get in contact with me.
1:40
Thanks for the code, now I can break into your house and know the code.
Best of luck to you.... if you heard what I said in the video... it was a temp code I made for the purposes of the video. The code has since been deleted and will not be back on until I decide to make another video. 🤣🤣
@@sevokevo I’m just jokeing with you man, have a nice day.
@@alexjansen7262 yeah I knew you was. I got a laugh of it for sure... I just always reply in a honest matter.
Can you hook it up to an existing siren from old security system or get a certain one that works for it?
When I got the upgrade to this.. they were able to install the adaptor which made my older equipment in the house interact with this unit
If alarm is off snd door or is open or broken will it just make the chime door open and not do anything else or what also if you have camera setup how far can it look back to see if anything has happen
No cameras at this time.... if the system is armed and someone breaks a window... the alarm will go off at the same sound as you heard here in this video... if its in Armed Away and the front door is open.. it will start beeping and gives you 30 seconds to disarm before it goes into a Alarm state and it goes off .. .. if you have it In Armmed Away and you open the back door.. it would go into immediate alarm state as the back door is not a bypass door while in Armed Away.... now if i go to Armed Stay... both doors will be bypass doors because I used Armed Stay when i am home so it will give me time to disarm before the alarm goes off.
how loud is the siren is it loud? Can you get an extra siren?
The siren is loud via the panel. It’s the same sound you heard in the video.... it may not sound loud here but trust me it’s loud enough if you in the house... no to loud that you can hear it very well Outside the house unless your close.. but this was the same amount of loudness as my older system was.... as for extra sirens... I am not for sure. I am sure ADT might have said equipment but I have never had a need to get one.
That long beep noise is the siren? Really? The system I had growing up would make that extended “beeeeeeeeeeep” noise for 45 seconds and after that if the code wasn’t entered, a very loud siren would blare until the alarm is disarmed.
Sort of disappointing that ADT doesn’t have something like that to actually scare off intruders.
A “beeeeeeeeeeeeeeep” noise/sound isn’t going to do much.
@@adamhoeg1311 the ones you see in movies with home invasion Intruders. Alarm going off sound. The beeeeepp is lame need more settings for sound options.
How do you silence the chime when you open the door while the alarm is off?
I don’t use the panel anymore but it will under your settings… probably in advance settings where you need to enter your code… i know it’s easy to find…
Editing my comment… mainly because I rushed to answer after seeing the notification without reading the whole message.
My cousin’s house has this alarm and whenever I have a sleepover with him, someone would accidentally set if off and it’s defining asf!
@@UmaysImran haha yeah it is..
Great video!
How do you like their service so far? Is it expensive monthly? Thinking about getting it
After taxes it’s like $70 a month... it works just fine for me however I do have older units around my house for my doors and glass breakage so I get issues 2-3 times a week of my old devices falling out of syncs for a few minutes which causes a warning alarm that I have to acknowledge for it to stop... this warning alarm I am talking about will not cause ADT to contact me... it will just beep continuously until I clear it..... I think upgrading the other devices I have will fix this issue... (I use to have an older control panel and I only upgraded to this new one because my wireless adapter on my old panel was about to be disabled by AT&T which is the carrier for the wireless signal... so an upgrade and a new 3 year contract was mandatory)
Heck yeah! It was $59 for 1 camera and the keypad. I needed an extra camera so it’s $70 with a little keychain pad monthly! Over $1,000 for the whole setup. 2 cameras and the wall mounted system
What does Arm Custom do?
It does the same as Arm away.. and yet i have no control on options yo adjust it. So not really for sure
It doesn’t make sense why it says exit now while arming it stay
You can blame ADT for that! Now I don’t have ADT anymore but my mom has it at her cleaners business and hers actually does not do that anymore so from what I know.. they actually fixed it
So when it's on test mode they won't respond to panic buttons? Also can you do a test of the fire button?
Test mode puts it in a safe state for all alarms that goes off.. this includes the fire and medical... in fact it something they recommend testing each month to make sure it is operating properly outside of its own self checks...
To put it in test mode. You have to go go your Account on the MyADT side and put it in test mode there.. when you do.. they will ask for a time limit.. and you all set.. just be sure that if you finish before the time limit you set to go back and take it out of test.
Also when you test.. you need to test to make sure ADT recieves the signal on their end by using the Logs (on the MYADT site or on the app) the panel sends which will happen even when it is in test mode.. but don't worry even though ADT systems will still get the signals.. they will not contact you as long as you have the account in Test mode.
why does it say exit now, when you press arm stay?
Your guess is as good as mine.. that’s just what it says… I can’t stop it from doing that… it’s how ADT programmed the software
Can you do a motion detector test
I don’t have motion detectors in my home
Can you make more videos?
So yeah i never got an alert nor a notification about this comment.. just now seeing it.... so like what kind of videos per say?
Like adt command test videos, I think it would be amazing.
@@rztndiii hmm let me think on it. If i do anything it will be here.. i might simulate a break in or something and record it all for people to know what happens or something
A L A R M E D 1:40
Do you know how to remove the panel from wall?
So i never got an email on your comments here so i just now seen them.. sorry for the delay.
The Tech when he first installed it after i asked said there is a screw at the bottom you have to take out. After you do so it should easily pop off.
Better than my stupid tech. He rushed through everything and I’m clueless ☹️
How to view the doorbell camera?
Sadly I don’t have one of those... but I would assume it mostly be shown via the ADT Control App.
1:40 When The Bass Gets Way too damn high
The Bass LOL
can u make a video about testing the system and the panics I really wanted to watch a adt command test please make a video about testing 😫
If I do. It would probably be a few small videos instead of one big video
Mine did it when I didn’t disarm the system.
As is suppose to... if you don't disarm within the bypass period it will go off.
@@sevokevo Thanks for talking about that!
Sounds like Star Trek Red alert
Nailed it! Lol! It should be known that this alert only goes off on Androids.. the IPhone make a less fun sound
How do we get them to put a big brother screen in their own home?
Simple.
….. sure!!! I have had ADT for over 6 years and had nothing when it comes to spying or anything
@@sevokevo
And you know this how? A monthly reminder: Still not spying on you, birthmark boy!
@@gregdiprinzio9280 and what proof do you have that they are spying on you????? You have no proof that’s why your conspiracy does not have any weight on it
@@sevokevo
There's a camera and microphone on the command module. There's a (probably bored, sexually deviant, accustomed to invasion of privacy) human being (with no morality and a "keeping you safe" rationale) with access to them. What could go wrong?
@@gregdiprinzio9280 that does not prove a damn thing! Front camera is used when someone fails to disarm the panel and I get the pic from my app… the mic is used to record from it… not to mention that it also use to have Alexa intergraded into the system but not any more… but still that does not give you ANY EVIDENCE that they are doing as you said so enough with your trolling conspiracy BS!
I'm an Amazon seller and I have a battery for the ADT Command Panel, are you interested in testing our product for free?
no thank you
What happens if I turn on alarm for away and my door gets open and I don’t disable the alarm what will happen after that will cops come or will the alarm just keep going till I stop it?
If your door gets open.. it will give yoi 45 seconds to disarm the system before the alarm goes off... after which if the alarm is not disarmed within 15-30 additional seconds.. then ADT will contact me to acknowledge the alarm and see if everything is alright.. and will also ask for my special word i have setup to know its me or not... if i am not home when this happena and i acknowledge i am not home. They will contact the local police.... if the alarm calls and i don't answer the phone when they call. They will contact the local police then contact my family and let them know that my alarm has gone off and have been unable to get in contact with me.
Mete
Mete??