Could you cut a section out of a junk rim to substitute the blue piece on yours? I have trailers and trucks with 14, 15, and 16" rims. I'm guessing the center hole in the rim (no matter what the diameter) would have enough sideways movement no matter what size. Otherwise you'd need to make size-specific angle iron bars? Great video by the way!
Можно попробовать приварить к поперечине не одну а две нажимные пластины. Поперечину соединить сваркой с трубой дя одновременно го отжима пластинами Место контакта диска и шины смочить мыльным раствором.
Could you cut a section out of a junk rim to substitute the blue piece on yours? I have trailers and trucks with 14, 15, and 16" rims. I'm guessing the center hole in the rim (no matter what the diameter) would have enough sideways movement no matter what size. Otherwise you'd need to make size-specific angle iron bars? Great video by the way!
Den Reifen beim Wulst abdrücken drehen und an verschiedenen Stellen abdrücken wäre effektiver!
In the blue piece you can have different holes. So that you can do small or larger rims.
Very nice set-up! And simple.
Thank you
I use a small 2 ton jackby putting the wheel on the ground and put the jack on the tyre close to the rim and Jack off my towing hitch.
Можно попробовать приварить к поперечине не одну а две нажимные пластины. Поперечину соединить сваркой с трубой дя одновременно го отжима пластинами Место контакта диска и шины смочить мыльным раствором.
Когда коту делать нечего😅
Nice put a strip of flat metal on that bead breaker plate so it won't dig in so it can press tire along with bead breaker
Yes good idea.
Like the piece of wood ur using but metal welded
Thank you.
maybe a ratchering box wrench ?
Yea it'll probably come in in handy. It'll be faster.
😎👍
No doubt the setup works but I wouldnt use it on a tire to save. ...bead would be damaged.
Never damaged one yet.
Well, there's five minutes I'll never get back. That contraption doesn't work very well at all!~
This contraption worked just as well if not better than the many I’ve seen so far.
I could use some design fine tuning.