Battery Switching Circuit Board : switching @ 11 Volt

Battery Switching Circuit Board : switching @ 11 Volt
3 x LIFEPO4 12.8V 10A batteries
Between CHARGE Batt and LOAD : 150W Voltage Boost Converter
LOAD : 5W to 60W
RADIANT CHARGER : R-EMF Charger
About the Battery Switching Circuit Technology
This circuit board was designed by Energy Batlabs & Magnetic Impulse Tech Group LLC to allow for the switching of battery banks in your DIY energy project. This board provides the logic to be used with relays which will allow you to charge one battery bank while utilizing another during continuous operation.
Those who are familiar with the Bedini School Girl Radiant Charger will find this as a welcome solution to your battery swapping needs. In the past experimenters had to manually swap power supplies or create their own automated solution. This charging board does the “battery babysitting” work for you.
The circuit board is made to switch between 3 discreet battery banks. USE OF NEW BATTERIES HIGHLY RECOMMENDED. This logic board is 96mm X 64mm. It requires a charger, 1 12v primary battery, 3 secondary batteries (12, 24, 36, or 48v) and 6 mechanical relays (12vdc 100A). DO NOT USE SOLID STATE RELAYS.
This battery switching board has one floating input (+and-) to sense load battery voltage. There is a voltage control Potentiometer on the board which sets the trip point between 9 and 16 vdc. When the load battery voltage drops below the set point, the external relays will sequence the 3 batteries. The sequence goes between three states for each battery:
1) battery charging
2) battery resting
3) battery discharging (powering load)
This sequence continues indefinitely.
The chip on the board is a decade counter, it goes in a ten number sequence but It is reset after three. This board is designed for the experimenter as the board does not use surface mount (only thru-hole) so you are actually able to change a part yourself.
This board is a rugged design and is fused (5amp). This board has been rigorously tested by its development team. It does not come in a box, if user wishes to put this board in a box it needs to be a ventilated. The board has an adjustable resistor that can be set within a 10th of a volt (12 turns)
Applications / Ideas for use of Battery Switching Circuit:
1) Bedini School Girl type Radiant Charging Battery Swapping
2) Solar energy solution systems - use to help extend your energy usage
3) Wind energy solutions systems - use to help extend your energy usage
Order here
energybat.com/...