Thanks brother, I was afraid to try to twist off the cap as it was like it was welded on. Your video gave me the courage to break out the vise grips and channel locks. It still was scary as the bugger was really stuck. I then put a little wd40 and some heat to it and finally, it broke free.
Here is the way that helped me. The nozzle jammed and gave a straight stream, the pressure was ok. What I did: "I found a way to start the nozzle without disassembling it. Just squirt the lithium grease in the spray inside the nozzle from the outlet side. Lubricating even a wet nozzle makes it run like new. 20 minutes. Then you have to repeat it and the working time is longer. Fairy tale. I recommend it. I used CX80 Lithium lubricant. " My nozzle got a second life, after a few cycles with grease, I washed 350 square meters of the driveway. RECOMMEND
There's a much easier way to fix it. Take the dirt blaster off, drain any water out and dribble some ordinary oil down the outlet hole. That's it, no dismantling needed.
Didn't work. Just bought a new K7. First one broke within 4 hours, second one lasted 2. It's a crappy design. I took it apart and could not find any dirt
No arreglaste nada de nada, lo único que hiciste fue desmontar la boquilla. Y después dices de ser respetuoso cuando tu estás tomando el pelo a la gente. Pailan
Thanks brother, I was afraid to try to twist off the cap as it was like it was welded on. Your video gave me the courage to break out the vise grips and channel locks. It still was scary as the bugger was really stuck. I then put a little wd40 and some heat to it and finally, it broke free.
Glad it helped 👍💯
Here is the way that helped me. The nozzle jammed and gave a straight stream, the pressure was ok. What I did: "I found a way to start the nozzle without disassembling it. Just squirt the lithium grease in the spray inside the nozzle from the outlet side. Lubricating even a wet nozzle makes it run like new. 20 minutes. Then you have to repeat it and the working time is longer. Fairy tale. I recommend it. I used CX80 Lithium lubricant. " My nozzle got a second life, after a few cycles with grease, I washed 350 square meters of the driveway. RECOMMEND
Worked a treat. Thank you!!!
☺☺
Can someone tell me what is the size of that o-ring ?
How can I disasemble the gun
The ball bearing needs to protrude more, one fix is to place a small washer or two under the ball to raise it .
❤
Fixed! Thank you.
Ur wlcm 💪🤘
Good
Thanks
Nice...i fixed mine ...thank you !!!
There's a much easier way to fix it. Take the dirt blaster off, drain any water out and dribble some ordinary oil down the outlet hole. That's it, no dismantling needed.
All you did was take it apart and put it back without any result
Thats the point to remove debris you need to take it apart and to make it work again you need to put it back
Didn't work. Just bought a new K7. First one broke within 4 hours, second one lasted 2. It's a crappy design. I took it apart and could not find any dirt
Problem is in design
No arreglaste nada de nada, lo único que hiciste fue desmontar la boquilla.
Y después dices de ser respetuoso cuando tu estás tomando el pelo a la gente.
Pailan
actually you didn't fix anything. You've just disasebled the nozzle and that's it.
And it worked 🤣
What a load of crap, you didn't even clean it properly. The bearing was in too far to work properly ha ha
Didn't work