Hi, I own a shop in Montreal, Canada and a customer pointed this out to me. Great job! Thanks for the video. Simple, short, and to the point. Great work!
Hey Lachie, thx for putting together tips and all that - really helped me dial “leading edge” jibes in low wind. I’ve just started recording 360 video using a selfie stick attached to my rear handle - pretty crude. Just published my first clip. Anyway, I happened to notice your rather unusual selfie-stick setup on this video. Can you comment on its design/effectiveness? How does it compare to your typical mount at the end of the main strut? Keep up the stoke. Thanks, -Stuart
@@boardmaverick copying my answer here too in case you missed it on your other comment - it gives an epic POV but the setup is a little annoying and can get a bit twisted with the wing leash. I much prefer my end of strut mount that I 3d printed nowadays because it is less effort to setup, stays out of the way and the POV is equally as good
I didn’t have any issues with it tangling through manoeuvres. Every now and then I’ve found myself catching both the harness line and the back handle at the same time after a tack though. Not a major as you can quickly drop it and pick up just the back handle
Hi, I own a shop in Montreal, Canada and a customer pointed this out to me. Great job! Thanks for the video. Simple, short, and to the point. Great work!
Hey Lachie, thx for putting together tips and all that - really helped me dial “leading edge” jibes in low wind.
I’ve just started recording 360 video using a selfie stick attached to my rear handle - pretty crude. Just published my first clip.
Anyway, I happened to notice your rather unusual selfie-stick setup on this video.
Can you comment on its design/effectiveness? How does it compare to your typical mount at the end of the main strut?
Keep up the stoke.
Thanks,
-Stuart
@@boardmaverick copying my answer here too in case you missed it on your other comment - it gives an epic POV but the setup is a little annoying and can get a bit twisted with the wing leash. I much prefer my end of strut mount that I 3d printed nowadays because it is less effort to setup, stays out of the way and the POV is equally as good
Does it work with a boom? Thx
Does the harness line catch on your helmet when you do a transition - as alot of harness lines do?
I didn’t have any issues with it tangling through manoeuvres. Every now and then I’ve found myself catching both the harness line and the back handle at the same time after a tack though. Not a major as you can quickly drop it and pick up just the back handle
I am going to put your video on my website if that is ok?
Go for it! Appreciate you sharing it around!