I am happy with the results moving forward. Once I put that wheelie bar on and lean the tune more, it will be guicker. I have to put flm forever drive cups on as I break the dog bones drive pins.. I do have stronger dog bones I made, and I can run the Taylor IRC cups
Still same rpm at this stage, I still need to lean the carby as it still running rich. Once I put the wheelie bar on and leaned I the tune, it would be a lot quicker and should be rpm on top end. No, I do not have gps at this stage. The dog bone snap the drive pin.
Que foguete 🚀 🚀 🚀
The clutch did not break , it was the dog bone pin snap😮
Very nice
Thanks Bud.
With" big power" comes" big problems". Sounds like your getting her dialed in though
I am happy with the results moving forward. Once I put that wheelie bar on and lean the tune more, it will be guicker. I have to put flm forever drive cups on as I break the dog bones drive pins.. I do have stronger dog bones I made, and I can run the Taylor IRC cups
Put the wheelie bar on lean it out she'll hit Mach ten . Also need to hire an umpa lumpa fetch your rig ! 💥💥👊
For sure, it needed a wheelie bar. When I was into boats, I had a tug boat to bring it back
Still same rpm at this stage, I still need to lean the carby as it still running rich. Once I put the wheelie bar on and leaned I the tune, it would be a lot quicker and should be rpm on top end. No, I do not have gps at this stage. The dog bone snap the drive pin.
What RPM and what MPH? Did it go up?
There is a video explaining the run I did before this video