How to install a WEWE Single Handle High Arc Brushed Nickel Pull Out Kitchen Faucet

Поділитися
Вставка
  • Опубліковано 15 жов 2024
  • How to install a WEWE Single Handle High Arc Brushed Nickel Pull Out Kitchen Faucet
    How to install a new pull down kitchen faucet
    Get amzn.to/3u69lyc
    WEWE Single Handle High Arc Brushed Nickel Pull Out Kitchen Faucet,Single Level Stainless Steel Kitchen Sink Faucets with Pull Down Sprayer Sleek Design---Tulip kitchen faucet design make your kitchen room simple and fresh, easy to match most sink.
    Multifunctional Outlet Water Effect---3 way spray setting(STREAM,SPRAY,PAUSE),stream for filling water, spray for rinsing, pause for avoiding splashing in multitask mode.CEC listed. Flow Rate: 1.8 Gallons Per Minute.
    Easy to Install---Pull down hose and water Line hose altogether preinstalled in kitchen faucet to save much time under the sink,no require plumber,finish DIY installation less than 30 minutes.
    Easy to Operate---Single handle control water temperature and flow volume easily,high arc 360 degree swivel spout supply full range washing access, sprayer head always retract back to spout after each use.
    Easy to Maintenance---Superior corrosion & rust-resistant finish prevent dirty from sticking to faucet surface, clean faucet by cloth is enough in Daily Use.

КОМЕНТАРІ • 8

  • @adamfatah6467
    @adamfatah6467 8 місяців тому +1

    Good job man

    • @TomLeeman
      @TomLeeman  8 місяців тому

      Thanks it was hard getting the old one out

  • @Memegirl716
    @Memegirl716 8 місяців тому +1

    Thank you for sharing. I just purchased one and I’m going to install it. You have patience and are humble. Thankful for this vid.

    • @TomLeeman
      @TomLeeman  8 місяців тому

      Glad it was helpful! Good luck on your install and thanks for watching

  • @ridingblues
    @ridingblues 9 місяців тому +1

    You are so patient!

    • @TomLeeman
      @TomLeeman  9 місяців тому

      Thanks I appreciate that. And thanks for watching. Good luck on your install.

  • @doodoohead411
    @doodoohead411 2 місяці тому

    why are you using a basin wrench to tighten a water stop ?? lol , that's the wrench your suppose to use and tighten the faucet down to the sink ( where you said you would need to get some other type of tool) flip the head over sideways to turn nut left or right up in the tight spot.

    • @TomLeeman
      @TomLeeman  2 місяці тому

      Thanks for those excellent tips