6:16 Those two "rubber bands" are actually O-Rings. One should have been installed on the magnetic adaptor before you install it. That is why your nozzle is loose.
You're video was an absolute help for properly installing air assist. While using my air assist the tube moves and hits my project, which then messes up design, the wood moves. What can I do? the tubing is placed correctly but it hits the lid and I think that's why it moves, so I have to pause move the tubing and continue. I do keep it attached all the time, even while engraving.
How in the world you got the nozzle mount aligned with the module if it has to be really tight? I can’t! Any tips? Does it really have to be tight tight?
My lens mount stopped a little before it was aligned. So I had to push it hard til it was aligned. I assume it has to be tight if it needs to be aligned with module, because when I put the nozzle mount over it moves.
Under the module, right next to the laser, it pops in and magnetic. You don't have to keep it in unless you are using it. However, in this video I only used the laser.
Excellent video. Very well explained and not too fast but not too slow. Great work
Thank you!! I always feel I go too fast!
This is the best instructional video! Easy to follow and you spoke slowly and clearly. Awesome job! 👏🏾👏🏾 Definitely subscribed!
Thank you so much this was a big help I had been putting it off for so long!
6:16 Those two "rubber bands" are actually O-Rings. One should have been installed on the magnetic adaptor before you install it. That is why your nozzle is loose.
Thanks for the helpful tip!
Great video! Super easy to attach!
Great video. Just got mine and this helped so much.
Thanks you made it look easy I have mine on the riser is that going to make a difference
You helped me so much thank you. ❤
You're video was an absolute help for properly installing air assist. While using my air assist the tube moves and hits my project, which then messes up design, the wood moves. What can I do? the tubing is placed correctly but it hits the lid and I think that's why it moves, so I have to pause move the tubing and continue. I do keep it attached all the time, even while engraving.
That's great! I'm glad you were able to fix it!
How in the world you got the nozzle mount aligned with the module if it has to be really tight? I can’t! Any tips? Does it really have to be tight tight?
My lens mount stopped a little before it was aligned. So I had to push it hard til it was aligned. I assume it has to be tight if it needs to be aligned with module, because when I put the nozzle mount over it moves.
Make sure you install the O-ring to the mount before you screw it on. This will help to keep it snug and in place.
Where is the gold blade at the end
Under the module, right next to the laser, it pops in and magnetic. You don't have to keep it in unless you are using it. However, in this video I only used the laser.