Stihl MS440 with MS460 cylinder

[@SmithFarmTilton]

Where in NE are you located if I wanted some work done? Thanks.

[@NewEnglandChainsawWorks]

Connecticut

[@majorpixchannel7146]

Did you say you had to so some work to the cylinder? Im about to do the same install.... Does it bold straight on? Thanks 🙏

[@NewEnglandChainsawWorks]

You have to enlarge the base gasket holes on the cylinder and narrow the base of flywheel and pto side of the cylinder as well

[@majorpixchannel7146]

@@NewEnglandChainsawWorks Thank you sir 🙏 this is a build iv never done, and you have saved me loads of recharge

[@beaver5847]

Could you do anything with an 056 super? Runs, maverick air from bottom end

[@NewEnglandChainsawWorks]

Like port work?

[@beaver5847]

@@NewEnglandChainsawWorksdo you work for hire? Would like a complete rebuild, I was advised the crank case is warbled out where crank bearings seat