I have a NSR/NSF Series with a XR03CX Digital Controller. How can I change from degree F to degrees C? Also, I think I messed things up trying, is there some way to return to factory settings?
Could anybody tell me please how to set LS, Us, Hy , if controller dixell is installed on the storage boiler, and I want to have permanent hot water around 50-55 °C.
I did the same thing,I have the temperature in Celsius I set the temperature at 10 degree celsius but it shows 32 degree celsius,after I select the 10 degree celsius I need to press the set button few seconds?
Good day, The temperature setting does not represent the physical temperature inside the unit. To set the temperature as shown, you press and hold set until it start flashing, adjust the temperature and then press "set" once. For example: if the display shows 32, this is the current inside temperature. Press and hold set for few seconds, it will start flashing, you can then set your request temperature to 10. Press SET once, and it will go back to 32 which is the current physical temperature inside the unit. We hope this helps, thank you for reaching out!
This may be a dumb question but doing this will achieve what exactly? It’ll change the inner temperature to that degree and keep it there? Will it keep increasing by the measure inputted or something else?
Thanks for sharing knolage
How do you change temperature setting ?
I have a NSR/NSF Series with a XR03CX Digital Controller. How can I change from degree F to degrees C? Also, I think I messed things up trying, is there some way to return to factory settings?
@ZK Refrigeration hvac That would be wonderful. Thank you.
👍👍👍👍
Could anybody tell me please how to set LS, Us, Hy , if controller dixell is installed on the storage boiler, and I want to have permanent hot water around 50-55 °C.
Is there a way to force my thermostat to be a freezer?
I did the same thing,I have the temperature in Celsius I set the temperature at 10 degree celsius but it shows 32 degree celsius,after I select the 10 degree celsius I need to press the set button few seconds?
Good day,
The temperature setting does not represent the physical temperature inside the unit. To set the temperature as shown, you press and hold set until it start flashing, adjust the temperature and then press "set" once.
For example: if the display shows 32, this is the current inside temperature. Press and hold set for few seconds, it will start flashing, you can then set your request temperature to 10. Press SET once, and it will go back to 32 which is the current physical temperature inside the unit.
We hope this helps, thank you for reaching out!
Sir ..how I connect you.
This may be a dumb question but doing this will achieve what exactly? It’ll change the inner temperature to that degree and keep it there? Will it keep increasing by the measure inputted or something else?
Nice