Okay not to sound stupid but I have the pdp 3.5 f series. I was just about to buy the 18 round blue top for the compact gun. Will this fit? Or do I need to buy the red top mag?
Pdp F series..10rd magazine w/orange follower and slim basepad (identical to 15rd) NOT the 1/2 plastic 10rd magazine.... will your bumpers work on them to run a magwell? Lower factory basepad on those 10rd mags is a slim plastic clip... looking for a magwell in a restricted capacity state SMH. Lmk im willing to be a test subject. I reached out to LOK w/ no reply yet.
@@MrOttovon1 probably when we get closer to being out of the anodized. We sell far fewer raw so we only set a dozen or so aside when we run the batch. The rest go to anodize
Hi, im having a bit of a issue with your PDP +4 basepad. I have the original 18rd mag, i remove the basepad take out the spring, replace with spring that comes with the +4, put the little metal piece on bottom of spring and then slide and screw on the +4. I can only get 19 rounds in the mag. It won't allow any more. Any ideas?
Will you be making magwells for the PDP/F anytime soon?
Will these fit with lok grips compact magwell? Looking to get the +3 ext. Thanks
Will the 18 rounder +4 base pad fit the pdp pro sd with it's mag well that comes on the pro sd?
Yes
Okay not to sound stupid but I have the pdp 3.5 f series. I was just about to buy the 18 round blue top for the compact gun. Will this fit? Or do I need to buy the red top mag?
No it won’t. They are shorter. Requires a different rod. We sell one specific to the 3.5 F
I think this went over my head. I have a stock compact pdp(not pro so no magwell) any of the extended basepads work with it?
Yes bumpers and the +3
@@zrtacticalsolutions Thank you for the reply. Love your services. I'll be getting one or two of those +3 plates then
Pdp F series..10rd magazine w/orange follower and slim basepad (identical to 15rd) NOT the 1/2 plastic 10rd magazine.... will your bumpers work on them to run a magwell? Lower factory basepad on those 10rd mags is a slim plastic clip... looking for a magwell in a restricted capacity state SMH. Lmk im willing to be a test subject. I reached out to LOK w/ no reply yet.
Yes. Yes they do.
Will this work for the full size pdp pro sd?
Good question.
What option do we go with if we remove the magwells from the SD or SF match?
They work without the magwell but we don’t recommend you remove it because the tubes rock and can jam the slide. It’s a problem with the steel frames
Do you have instructions on how to install the brass base pad?
Push the retainer up and slide off. Slide the new one on.
@@zrtacticalsolutions Thank you. Ordered the brass pad and a captured guide rod. Any idea when the Stonewashed pads will be available?
@@MrOttovon1 probably when we get closer to being out of the anodized. We sell far fewer raw so we only set a dozen or so aside when we run the batch. The rest go to anodize
Does bumper fit walther pdp pro sd?
Yes
Hi, im having a bit of a issue with your PDP +4 basepad. I have the original 18rd mag, i remove the basepad take out the spring, replace with spring that comes with the +4, put the little metal piece on bottom of spring and then slide and screw on the +4. I can only get 19 rounds in the mag. It won't allow any more. Any ideas?
Remove the keeper from the bottom of the spring. It won’t seat into the basepad…
@@zrtacticalsolutions Thanks!
That was confusing as hell