yes I did, I found it in this article: "The theoretical and experimental investigation of blank holder forces plate effect in deep drawing process of AL 1050 material"
@@kenzabouchaala8828 in this tutorial after coalition they gives warning because of that I didn't get results that warning are 'processing attributes defined on reference point can't be plottes by viewer' And 'Boundary condition are shown in local coordinate system in which they were defined'.
Thanks greatly! really helpful for Hybrid material analysis
Thanks a lot! It is quite helpful for beginners to learn Abaqus.
thank u so muchhhhhhh, really helpful, i wish u the best
Thank you for this great tutorial. How much time does this simulation take?
Thanks you for the whole analysis. At 6:30, how is the plasticity table is calculated? Any reference to make this table?
can you show procedure of encased stone column in abaqus
Could you please tell me when the punch stop move down? Is there any time limit for the punch?
thank you very much
could u help simulating the springback
thank you sir but how can I plot fld results for cup formed
anh có thể giải thích giúp em tại sao khi unload lại có hiện tượng blank nảy lên không ạ
Thank you very much. could you give us the material sheet
Can you send the whole file for this analysis.... Please??
Thank you for this tutorial
is it possible to simulate spring back
Thank you in advance
You're welcome. I hope it can help everybody.
yes
what the Unit your answer
what are the units of mass density, how do you go from 2700 kg/m3 to 2.7x10-6 lmao
he is working with mm instead of m. 1m^3 equals 1e+9mm^3.
So your density is (2700kg/m^3)*(1m^3/1e+9mm^3) = 2.7e-6 kg/mm^3.
please would you tell me from where you take the mechanical properties of AA1050 and thank you in advance
did u found it ? cause i really need it !
yes I did, I found it in this article: "The theoretical and experimental investigation of blank holder forces plate effect in deep drawing process of AL 1050 material"
@@kenzabouchaala8828 in this tutorial after coalition they gives warning because of that I didn't get results that warning are 'processing attributes defined on reference point can't be plottes by viewer'
And 'Boundary condition are shown in local coordinate system in which they were defined'.