It is true that you can measure flatness with v block and filler gauge. To measure flatness correctly, you need three jack screw minimum and lift your part of the surface plate. you make sure that your dial indicator should be zero at three points where jack screw is.and then run an indicator on your parts.
then what you actually want to say? that mean I will always choose orientation tolerance not form tolerance. Because orientation cover form too right? you should have given some strong practical example that stand why I will go form tolerance instead of orientation tolerance. same block part doesn't stratify anything here
Indipendent features (straightness,flatness,circularity, cylindricity) have no datums.. Dependent features (angularity, parallelism, concentricity) have datums.. This is what you mean..
It is true that you can measure flatness with v block and filler gauge. To measure flatness correctly, you need three jack screw minimum and lift your part of the surface plate. you make sure that your dial indicator should be zero at three points where jack screw is.and then run an indicator on your parts.
Yes right , Can you send a video on it ????
Fir parallelism kaise check hoga
Great aashish welldone
👍👍👍👍👍👍👍👍
Raj
Informatic video
very good explanation and i appreciate you sir
Sir squareness and taper me kya differnce hai bataye
Please make video on position tolarance
Thank you... Bro...your video gives me an idea about the concept..
Gud work sir
Different between straightness and flateness please make video soon
Machine performence& risk opportunity ka. Video bnaiye
Good QA videos but can u make a video about roughness and his types..
sure bro i will
Dear sir please make a video about symmetry and how will check symmetry?
Sir kki book bataye iske liye
Very nice
Sir , what is different between tapper , flatness or parralasim
Nice video sir
Bro ek Aisa video banao gisme run out total run out perpendiculity kya hoti hai or kaise mesure krte hai
then what you actually want to say?
that mean I will always choose orientation tolerance not form tolerance. Because orientation cover form too right?
you should have given some strong practical example that stand why I will go form tolerance instead of orientation tolerance.
same block part doesn't stratify anything here
If a plane is parallel within a range of 0.2 so it is flat also within 0.2 , right?
yes on one face it's Flatness may be 0.2 and on other face flatness may be about to Zero
Verry nice video sir
nice good going keep it up
Sir pls make a vdo on H7 g9 etc
Pls sir
sure bro soon i will do
From which subject in btech u got knowlege of flatness & parallelism....
Metrology
Parelite ka symbol kya hota hai?
Super sir
If the flatness of Datum plane 0.002" & measured plane flatness 0.010" then how much is it effect on parallelism ??..
Good
Super
Cc or sc parameters kya hai
bhai 1st principle kya hota hain pls reply me
Thanks bro
Bhai cylindricity ka video kab banaoge
bana rakha h bhai playlist me mil jayega channel pr
ok
apna chera poor a na dikhakar side me chal rahe measurement ko full skreen par dikhaye please sir
Development ke document ki video bnao sir
OK bhai banaunga jaroor
bro plz explain symmetricity as well
OK bro
Yes sir please
Indipendent features (straightness,flatness,circularity, cylindricity) have no datums..
Dependent features (angularity, parallelism, concentricity) have datums..
This is what you mean..
yes exactly
basically its the difference btn those 2..but why I will choose form strongly that is missing.
Apqp, ppap per वीडियो
OK bro soon
Video banao or practical dikhao
Abe haath band kro yaar🤣🤣🤣