You can take old cape then use cape front side easily cut for that . Ithink this is a better idea .becuse cape plastic quality is good . Iam using unicorn So unicorn monoshock not protected to Raining season. Becuse iam using same method this is very help full for monoshock protection and dust free also
Kudos to you...explaining it in english .. I have seen some people putting caption in english and talking in any other language ..which so much irritating ..
Good hack and presentation 👍🏼 . You might want to cut the 3m in smaller strips so that water doesnt accumulate and reduce adhesion .. also check out the 200 NS mudflap design .I think it'll do a better job Honda should have given some provision to fix flaps . Think they forgot about Indian roads & rains
@@AmalSenan That answers my question. I'm also getting the Carbon racing mudflap, even though that one seems to be a bit expensive. I didn't want to drill holes in the mud-guard, and thought 3m tapes would be a better option.
@@PardeepSingh-zd9zr did you install the carbon racing mud flap? I’ve just ordered mine and it says that they are sending double sided tapes as well as nuts and bolts so as to give us the option as to how we want to fix it, Lemme know what you did.
@@AmalSenan do u have tested it in high speed bcoz some people had complaint regarding its rigidity in high speed as it's tend to bend.. I'm about to get d delivery from a showroom located 500km away from my locality after d covid scenario normalisation..so in that case.. Will this survive?? Already got 3m tape n spray paint..plz share your experience or any alternate against d same..🙏🙏🙏
This predominantly happens when we rave the bike too much in city at low speeds, or we wash it immediately after ride. It's the effect of heat on the metal. No much solutions. Can avoid further decoloration by taking care above. Same with me also
Just finished 5 months with this on my CB 350, did 2 rain rides to hills and one off road. Still its there. Try it with correct method. Will stay. Also it better to loose a plastic sheet than drilling our mudguard. This is not a perment solution but just a hack 😄
I have got TVS XL mud flap for ₹20 and just pasted it with Anabond. It was a perfect fit.
I don't have Honda H'ness but very good work sir... 😇👍🏼
I think of a close friend of mine from school. Some kind of dejawu. Immediately subscribed dude. Good luck.
❤
I like the word used "Beautiful" at 13:43. Yes, it indeed is a beautiful bike
Superb. Will try this for my cb350RS. Have to make it a little longer than this measurement.
I tried with 3M tape, but it feel off....
Is your 3M tape still holding?
You can take old cape then use cape front side easily cut for that . Ithink this is a better idea .becuse cape plastic quality is good . Iam using unicorn
So unicorn monoshock not protected to
Raining season. Becuse iam using same method this is very help full for monoshock protection and dust free also
Kudos to you...explaining it in english ..
I have seen some people putting caption in english and talking in any other language ..which so much irritating ..
Good hack and presentation 👍🏼 . You might want to cut the 3m in smaller strips so that water doesnt accumulate and reduce adhesion .. also check out the 200 NS mudflap design .I think it'll do a better job
Honda should have given some provision to fix flaps . Think they forgot about Indian roads & rains
Good suggestion 👌
Does the tape fix is ok
Nice workaround! How is the 3m tape holding up while driving? I'm not sure how well it withstands the wind pressure while driving in wet conditions.
Almost 1000kms now , did 4 rain drives. OK till now. Now only time will tell
@@AmalSenan That answers my question. I'm also getting the Carbon racing mudflap, even though that one seems to be a bit expensive.
I didn't want to drill holes in the mud-guard, and thought 3m tapes would be a better option.
@@PardeepSingh-zd9zr did you install the carbon racing mud flap? I’ve just ordered mine and it says that they are sending double sided tapes as well as nuts and bolts so as to give us the option as to how we want to fix it, Lemme know what you did.
We can use a black coloured plastic file cover.
Use rx back wheel mudflaps. It will cost less than 50 rs
Bro wat about rear wheel mud flap..can d same be fitted to d rear one..
Yes , but easy is to bus a 20 ruppe rubber flap and fix it with 3m tape. I am using from March and its super successful
@@AmalSenan do u have tested it in high speed bcoz some people had complaint regarding its rigidity in high speed as it's tend to bend.. I'm about to get d delivery from a showroom located 500km away from my locality after d covid scenario normalisation..so in that case.. Will this survive?? Already got 3m tape n spray paint..plz share your experience or any alternate against d same..🙏🙏🙏
Lovely idea. Super thanks brother
Thank you too
My bike's exhaust colour is changing from chrome to yellow colour.... Plz help
This predominantly happens when we rave the bike too much in city at low speeds, or we wash it immediately after ride. It's the effect of heat on the metal. No much solutions. Can avoid further decoloration by taking care above. Same with me also
Still waiting delivery of CB350
Anyway Useful video
all the best ... its an awsome bike
good idea
Good idea but for a premium bike Paying 2.3L Onroad and no accessories ...c'mon Honda .I think better file a feedback to Honda ...
100%, Let honda use this as a shameful feedback so that they do it soon.
Now, that’s a good hack!
interceptor mud fenders costs only under 100 bucks, go for it.
It's not fitting properly, touching tyre
Wooow... Very helpful
Doesn't Fall ?
Intact till today
sir but its not durable it will wet and loose easily
Just finished 5 months with this on my CB 350, did 2 rain rides to hills and one off road. Still its there. Try it with correct method. Will stay. Also it better to loose a plastic sheet than drilling our mudguard. This is not a perment solution but just a hack 😄
Bhai ek mera bna do 😂
Thank you,very helpful
My money is safe ..................... 😂😂😂😂😂👍🏼👍🏼👍🏼👍🏼❤️❤️❤️
What is mileage of the bike cb350
35 in city and 40+ in highway
In hills it gives you around 32 km/ltr
Too good mod job 👍
I will install custom made flap from scraped tyres or truck tubes .
CB 350 RS: Mud flap and accessories : ua-cam.com/video/MHFiq_TrAw8/v-deo.html
സുപ്പർ 😍😍😍😍
Excellent solution.
Buy a continental gt mudflp
കൊള്ളാം
The comments are on now
Post a video on how to wash and maintain the bike and engine after mud flaps!
Good
Nice 👍
Good demo brother 👍
Glad you liked it!
Really helpful
Thank you . Share with friends
Nice one bro..
Good bro 🥰
സ്കെയിൽ കണ്ടാൽ മലയാളിയാണ്😪
സ്വാഭാവികം 😃
better buy a TVS moped Rubber mud flap rs.20
Amal ser 🔥
Good