Luca & Lorraine Baricchi - Balance in Movement

Поділитися
Вставка
  • Опубліковано 2 гру 2024

КОМЕНТАРІ • 13

  • @rogelee-TW
    @rogelee-TW 3 роки тому +1

    31:00 3 planes of Shaping is not cosmetic, it’s for balance and for the angle of compression. it’s swaying/shaping down,focus on the compressing side.

  • @rogelee-TW
    @rogelee-TW 3 роки тому +2

    25:00 Not fully articulated joints will cause unbalance and tension. So the warm up and oily joints is important.

  • @rogelee-TW
    @rogelee-TW 3 роки тому +2

    39:00 No stress in the frame, no push and pull to the lady, use and manipulate the feeling of fingers and core to the multiple spheres of lady’s body and get the correct respond.

  • @rogelee-TW
    @rogelee-TW 3 роки тому +1

    11:30 Double Compression, keep the angle for overlapping the sanding and receive leg. For longer range and fuller movement whenever it’s needed for the interpretation of the music or the mood, not everywhere.

  • @rogelee-TW
    @rogelee-TW 3 роки тому +2

    18:00 The correct compression angle is toward the partner’s groins for not knocking over partner. the power is in the lower body.

  • @rogelee-TW
    @rogelee-TW 3 роки тому +1

    32:30 Compression starts from back and down, power into the groin.

  • @rogelee-TW
    @rogelee-TW 3 роки тому +1

    Thanks for sharing this Wonderful lecture. 🙏🙏🙏🙏🙏

  • @rogelee-TW
    @rogelee-TW 3 роки тому +1

    35:00 One arm practice, be Very aware of the right side and all the spine and joints articulation, without the involve of the both Hands. It’s impossible to do pivot with one hand for the reason of centrifugal force.

  • @rogelee-TW
    @rogelee-TW 3 роки тому +2

    43:00 Bending the lady, not stretching the lady. All joints must be free.

  • @coolmint9970
    @coolmint9970 Рік тому +1

    Thanks

  • @danielsalomon7163
    @danielsalomon7163 2 місяці тому

    Good capture of the lesson too bad you can’t hear him over the translation

  • @d0maene
    @d0maene Рік тому +2

    This is fuckin' crazy. Excuse my language. But there is just no different way to say it