Desculpe eu não entendo o que você quer dizer. Por favor, seja específico para que eu entenda. Ficarei feliz em ajudá-lo. Este é um vídeo sobre como reparar a unidade de passo SWF e o diagrama do gerador de clock para fornecer um sinal de entrada
@@hassindoembro the twelve are working simultaneously, assuming that if they wanted to work only with four, the twelve would go down the needle bar, when the solenoid of each head is turned off, it does not lower the needle bar, when I turn on the same one with the solenoid out of point, it accuses failure of thread, but with everything right in the stitch, it's embroidering with all needle bars, I've never seen
hi! first of all thank u for the knowledge. i have a question! for the signal on the pa pb and cnt, its possible the signal generator do it? or only especifical signal? if was only especifical signal, its possible to you disponible this cods on some where to us to buy?
Hello. My device is SWF, there was a scissor problem after repairing the scissor drive, now the device system comes on, but it does not move in the X-Y direction. Thank you for your help. 
So good.sir.
Wow
Olá como faço esse simulador
Desculpe eu não entendo o que você quer dizer.
Por favor, seja específico para que eu entenda.
Ficarei feliz em ajudá-lo.
Este é um vídeo sobre como reparar a unidade de passo SWF e o diagrama do gerador de clock para fornecer um sinal de entrada
Hadir kwn kuh
Thank you very much for this effort
Hello, i have one swf 12 Heads, and ALL Heads while off, turn down, in same time
You mean the thread sensor doesn't work?
@@hassindoembro the twelve are working simultaneously, assuming that if they wanted to work only with four, the twelve would go down the needle bar, when the solenoid of each head is turned off, it does not lower the needle bar, when I turn on the same one with the solenoid out of point, it accuses failure of thread, but with everything right in the stitch, it's embroidering with all needle bars, I've never seen
Check the video description
there is a phone number,
send me a video so I understand the problem you are facing
@@hassindoembro where?
Video description
hi! first of all thank u for the knowledge.
i have a question! for the signal on the pa pb and cnt, its possible the signal generator do it? or only especifical signal?
if was only especifical signal, its possible to you disponible this cods on some where to us to buy?
Hi friends I am India my is problem E8010 Dahao main board
This is you what's app number send friends
Ok
Hello. My device is SWF, there was a scissor problem after repairing the scissor drive, now the device system comes on, but it does not move in the X-Y direction. Thank you for your help.

I mean, after fixing the stepper cutting driver.. But the stepper drive XY problem?
Pak Minta Nomor contact Nya.... Saya mau service mesin swf kpl. 1 ... Pak