Dental Suction Dürr Change Bearings
Вставка
- Опубліковано 16 вер 2024
- Change Bearings for Dental Suction Dürr
dental suction
repair dental suction
maintenance dental equipment
maintenance medical devices
planned preventive maintenance
change bearings
biomedical engineering work
Durr Dental Suction
thank you
Nice work
Good job
Durr tornado 70
Sering terjadi macet di capiler(memuai)
Jadi harus dibubut
Nice work. Could you also post videos of Durr compressor repairs. Like changing piston rings, flywheel replacement and bearing replacement. Thank you.
soon
good work!
Good job
How can I get in touch with you repair knight , need your assistance
repair.knight.medical@gmail.com
Hello, I am looking for the seal between the turbine and the Dürr Dental VSA 300 S motor?
Can you send to me air-water seperator inner circuit?
Thanks ! Now, i know how do it !
you are welcome any time
hi can you help me ? i have durr dental vs900s 220v 3 fase and i need to turn oned to 220v 1 fase
can you send me schematic for changed 220 v 3 fase to 220v 1 fase
thank you
Very good
imazing
May be you can help me.
I have durr dental vs 900s 3 fase and i need to change it to 220 V L1 N
Hello. Can you guys give the bearing size for the pump ?
it's different sizes , if you change for VS600 or VS900 or VS1200
but you can read size when you remove old bearing its shown there
Hi Sir, I have some questions. May I know why you hold the shaft to open the impeller center Nut (9.35)? Because when the holding part of the shaft is loosened. then you have a big problem.
What is the right way?
Hi: my after 30 minutes working, stop and motor doesn't spin. It's look like is heating. What's your opinion?
if stop working but you can rotate by your hand maybe overheat
you must check the piping maybe blockage
but if stop and motor stuck you must check the bearing
@@repairknight5996 I am having a similar issue. The impeller gets stuck randomly after using the machine. It suddenly becomes misaligned and stuck. If I rotate it manually it feels hard at first and hear scratches, then it will start rotating normally again but not for a long time before it fails again. What could be the problem?
@@hussaint548 bearing try to change it , or you can send video by WhatsApp
👍
جميل جدا
l have the vacuum motor and l need build suction system,but l dont know how l can do it
yes you can
share with me photo with your vacuum machine
@@repairknight5996 can you send me your mail adress?
l need your help pleace responce me
Hello sir.. where was the sucction part. In last where you kept your hand was sucction part..? And where air exhausted?
hello , which suction part you want to know it
can you please tell which minute in video
I will explain for you
you are welcome any time