''4:53 '' 16 inches 45 deg. elbow center is 254 mm,( 5/8 x 25.4 = 15.875 mm x 16= 254mm) thats why 8440-254= 8186 it is not about the weld gap. Thanks for sharing
no explanations of what u r referring to... incomplete information just doesnt make sense 16, 15.8 etc what are those dimensions specifically referring to?
Good evening. Trabaho ba talaga ng Pipefitter ang mga ganitong calculation or trabaho ng Craftsman? Apat na taon akong naging pipefitter construction and maintenance ni hindi ko naranasan sa trabaho yang calculation na yan.
i think yan po ang standard given na value ng formula paiba iba din po yan depende kung 45 ba or 90 degrees long or short radius 5/8 in fraction, 0.625 in inches, 15.875 in mm
I love this teaching and want to learn more. Thanks Dear❤
''4:53 '' 16 inches 45 deg. elbow center is 254 mm,( 5/8 x 25.4 = 15.875 mm x 16= 254mm) thats why 8440-254= 8186 it is not about the weld gap. Thanks for sharing
you are right nihat not the weld gap..the author used the 15.8 only ( lacking .075)
Yes this is the rigth computation.
❤nice idol
I think you miss to calculate (+-) like 252.6 to 253#. Sorry if im wrong.thanks for the formula
what is 670 verticle lines ?
what software is used to draw these drawings ?
5\8-15. 8 meant what nd where did com from plz reply me
That have converted into mm
why dont you do the take offs in inches
no explanations of what u r referring to... incomplete information just doesnt make sense
16, 15.8 etc what are those dimensions specifically referring to?
Good evening.
Trabaho ba talaga ng Pipefitter ang
mga ganitong calculation or trabaho ng Craftsman?
Apat na taon akong naging pipefitter
construction and maintenance ni hindi ko naranasan sa trabaho yang calculation na yan.
please correct it. what your idea share it
Hlo sir , could you send some pipe issomatric drawing pdf plz....
Boss spool na, d ky sfool
sir ano un 670 p? bat nandyan..
Take off 45 degrees L/R
T.O. = O.D. of elbow x 0.625 inch.
Take off 90 degrees L/R
T.O. = O.D. of elbow x 1.5 inches
Thanks sir"
Saan po nakuha ang 5/8?
i think yan po ang standard given na value ng formula paiba iba din po yan depende kung 45 ba or 90 degrees long or short radius 5/8 in fraction, 0.625 in inches, 15.875 in mm
Thank you for the lesson.
My pleasure!
Pa apply boss f hiring kayo baguhan pala po
Nice video but I need full lecture.
If you have any pipeline drawing in PDF format please can you send me for study on my email id
Boss hindi yn gaf, kon d gap yn boss
please correct it. what your idea share it
USING 15.8 IS WRONG YOU BETTER USE .625, OR 15.875 TO GET THE EXACT MEASUREMENT.
Boss 16x15.8 na boss,wag mong baliktarin ang given numbers.
please correct it. what your idea share it