ON EVERY YZ250 TWO STROKE YOU NEED A RACE GAS, BECAUSE OF DETONATION. EXCEPTION IS SPECIALLY DEVELOPED LOW COMPRESSION HEAD OR THREE CYLINDER BASE GASKETS, TO LIFT IT UP.
So I noticed unlike the stock linkage from yamaha, the NICE CNC one a ZERK fitting in middle of product intended for easy greasing on the go instead of tearing it .all.down.......IN MY EXPERIENCE , manufacturers NEVER seem to put enough grease in bearings, and other components so my question is, before the first use , did you.inspect Internals for adequate grease???.. Cuz no matter how good components are, subject them to mud, dirt, dust with little to no grease will wear out.most.components just as fast, IM OVER ZEALOUS with my greasing technique and I'll pump that grease gun until I see plenty of it coming thru and squeezing out...so again, thinking if u didn't pre grease the linkage liberally like I said maybe the reason for the premature wear............
Hello from UK pot scrubbers..
Do you need race gas when using this higher compression head? I believe they reduce the volume on this one so it is now higher compression.
ON EVERY YZ250 TWO STROKE YOU NEED A RACE GAS, BECAUSE OF DETONATION. EXCEPTION IS SPECIALLY DEVELOPED LOW COMPRESSION HEAD OR THREE CYLINDER BASE GASKETS, TO LIFT IT UP.
@@AutospeciLvAkumulatori Did you measure the head volume of this NiceCNC head? I just wanted to know before I buy.
NO, IT BLOWS GASKET IMMEDIATLY. WRONG CONSTRUCTION.
@@AutospeciLvAkumulatori Even the one that they sent you again? I thought it was an enhanced version and will cause no problem
So I noticed unlike the stock linkage from yamaha, the NICE CNC one a ZERK fitting in middle of product intended for easy greasing on the go instead of tearing it .all.down.......IN MY EXPERIENCE , manufacturers NEVER seem to put enough grease in bearings, and other components so my question is, before the first use , did you.inspect Internals for adequate grease???..
Cuz no matter how good components are, subject them to mud, dirt, dust with little to no grease will wear out.most.components just as fast, IM OVER ZEALOUS with my greasing technique and I'll pump that grease gun until I see plenty of it coming thru and squeezing out...so again, thinking if u didn't pre grease the linkage liberally like I said maybe the reason for the premature wear............
My problems with previous NICE CNC head and linkage:
ua-cam.com/video/NAVhvbL3a8A/v-deo.html
They replaced junk with more junk?
In this case, they said they tested the improved version on a motorcycle.
Pastāsti labāk kā darbojās jaunais hidrauliskais sajūgs yamahai
Ir čotka, iesaku. Darbojas tāpat kā KTM. Jo tas ir Brembo KTM sajūgs.
Cik viņam cena?
Nav dārgi.