I had this issue a couple months ago but ended up replacing the entire valve. It was quite gooey from lack of cleaning. I did not realize that I could get the clips from RPI though. Good to know. (I hear those M11 beeps in my sleep 😩)
Hey there, thanks for the video. I don’t have an issue with my knob going in reverse but I need to rotate my knob a quarter more for the function to work. For example in order to release water in the chamber, normally if you turn the knob a quarter it’s pointing towards the sign, but for my machine I need to turn the knob 180 degrees. Would I order the same parts to fix this situation?
You might have the wrong knob on there. There are 2 knobs that are almost identical except for the way they point. The correct part number is TUK049 from RPI. Look at this link and pull the knob. If the little metal plate is 90 degrees out, you know your issue. statimusa.com/product/tuttnauer-knob-for-timer-and-multi-purpose-valve-rpi-part-tuk049-oem-part-02450002/?network=g&device=m&keyword=&campaign=1001709004&adgroup=pla-296643753051&gad_source=1&gbraid=0AAAAADRqMG7KC1qDqlDKDZkHWZ678G1lh&gclid=EAIaIQobChMI3-GPs5regwMVjRatBh13-QdzEAQYASABEgJrifD_BwE
Bom dia amigão, por um acaso vc não teria o parafuso do manipulo da Dabi Bios, lembra muito da Tutnauer
Thank you so much for the detailed and nice video. Where should I order the the clips? Thank you
I had this issue a couple months ago but ended up replacing the entire valve. It was quite gooey from lack of cleaning. I did not realize that I could get the clips from RPI though. Good to know. (I hear those M11 beeps in my sleep 😩)
Love your videos. Have a problem with the timer knob getting stuck any suggestions on how to fix that? Thank you
Replace the timer RPI part number TUT008. It is not a bad idea to use the secondary egg timer as well.
Hey there, thanks for the video. I don’t have an issue with my knob going in reverse but I need to rotate my knob a quarter more for the function to work. For example in order to release water in the chamber, normally if you turn the knob a quarter it’s pointing towards the sign, but for my machine I need to turn the knob 180 degrees. Would I order the same parts to fix this situation?
You might have the wrong knob on there. There are 2 knobs that are almost identical except for the way they point. The correct part number is TUK049 from RPI. Look at this link and pull the knob. If the little metal plate is 90 degrees out, you know your issue.
statimusa.com/product/tuttnauer-knob-for-timer-and-multi-purpose-valve-rpi-part-tuk049-oem-part-02450002/?network=g&device=m&keyword=&campaign=1001709004&adgroup=pla-296643753051&gad_source=1&gbraid=0AAAAADRqMG7KC1qDqlDKDZkHWZ678G1lh&gclid=EAIaIQobChMI3-GPs5regwMVjRatBh13-QdzEAQYASABEgJrifD_BwE
I enjoyed this video! I currently have a tuttnauer 2340M and it is not reaching temp or pressure. Anyway to fix that?
Check the door switch. Does it click? The switch could be bad. Do you get a power light?
You have cute hands.
Thank you! 😘