HP ENVY x360 15-ee1024AU Screen Replacement

[@jmj429]

Thanks mate - wish I'd found this sooner. I watched some muppet say you just pop it out of the case all the way around - no mention of pulling out any adhesive - i ended up breaking the screen which, it turns out, wasn't faulty, just a loose connection with the 30 pin plug. A hard $200 lesson.

[@rickstechrepairs]

bugger

[@jrollins5741]

I had done a repair similar to this but instead of heat mat, I used a heat gun(blow dryer) to loosen the adhesive. That's of course acceptable correct. Cause the ultimate goal is soften the adhesive strips, making the removal a much easier task and helping to avoid damage to the digitizer?

[@mattvranjes7908]

I'm doing my customer's tomorrow, thanks Rick.

[@rickstechrepairs]

Good luck!

[@DapperIndividual]

I just replaced my screen (along with the exterior lid) but the sensor to close the lid doesn't seem to work, did I forget something?

[@rickstechrepairs]

I might suspect there is a magnet still on the old screen

[@patpinlac6277]

how much does this screen cost?

[@rickstechrepairs]

Depends on where you buy it, check out AliExpress

[@azimmahmudov2195]

👏👏👏👏👏👏

[@rickstechrepairs]

Thanks