How to Make LED CHASER using Arduino UNO-32 Patterns
Вставка
- Опубліковано 5 вер 2024
- In this video you can find 32 pattern of Led chaser using Arduino UNO.
Components used in this Projects are:
1. Arduino Uno
2. LED's
3.Bread board
4.Jumper wires
5.Data cable
Code & Circuit diagram
1drv.ms/f/s!Au...
GOOD JOB 👍👍👍👍
Nice👌👌👌
Nice
super
Hi, I'm still a beginner and I was wondering why you don't need a resistor for the leds ? Anyway, nice video and thanks for sharing the project.
Ya I didn't use resistor for led here because this led can glow (withstand) upto 5v.From Arduino UNO the output is 5V.I hope you have understand.
Thanks for sharing 🙏
@@360viewplus I did understand. Thanks !
even when its posible, i sugest to allways use a resistor! one of 100oHm will do it. than you have just a litle bit of protection. @@Shalakushka
@discovery1986
I agree dude
nice job, i get the code, but only 15 patterns? greets
can we operate this with switch on or off
Thanks for your kind. can we use mini arduino?
Yes sir,You can use Arduino nano also
@@360viewplus how about the pins? can we set the same numbers with Uno?
I have tried using UNO, it's OK, good Job. but when I tried it using nano, it does not work. why??
Yes
Check while uploading wheather the nano is selected correctly in Arduino IDE
Can you send me that code
FEW LED's LIGHT💀