Dr. Flexo - Best Practices for Plate Mounting
Вставка
- Опубліковано 29 бер 2016
- Does plate lift have you feeling under the weather? Dr. Flexo has the cure. In this daily dose, he'll demonstrate how to properly mount flexographic plates with tesa Softprint Secure to eliminate plate lift.
To assist with optimized print results and ensure process efficiency, Mark Andy Print Products supplies your pressroom with a variety of tapes offering solutions for all application demands. - Наука та технологія
It appears that you have used Lohmann DuploFlex 5.3 seeing how easy of application and demount!!!
Nice :)
You wish, Todd! This is tesa all the way my friend.
lets say you have a cylinder of 620mm and a plate of 540mm. how would you know where to place it? should it be 40mm on each side?
I wish that Tesa made letterpress tape for an old 4300
Hi Chris, thanks for your comment. To view all of Mark Andy Print Products consumable offerings please visit: shop.markandy.com
مساء الاحلام والامال الجميله المفيد ه النافعه غير مضرة لاتسان
I prefer 3m tape more than tesa
Hi Eddi, thank you for your comment. It's always depends on the label design, substrate etc.
You are wasting too much tape
🤷♂️
Thank you for your comments
Warum werden keine Schutzhandschuhe beim Umgang mit Lösemitteln getragen? Schwache Vorstellung.
This is too slow and not accurate, a real pressman doesn't use that big useless plate mounter, the old table top model is easier and better.
Quite possibly the worst demonstration iv ever seen😊