I would like to give you a suggestion... Since your machine seems to be not very rigid, try to cahnge your working strategy. Your AP should bela lot less thant what it is on this video, I would go max 0.05mm deep. But when going shallower, you hsould go faster with your feed, i suggest 0.03/0.04mm/tooth and between 100 and 140m/s as cutting speed.
where to buy this machine?
Try
DOC= 0.1mm
And diesel ⛽️ as flood coolant
Was the mole still reusable after casting?
鋳造後も型は再利用可能でしたか?
I would like to give you a suggestion...
Since your machine seems to be not very rigid, try to cahnge your working strategy.
Your AP should bela lot less thant what it is on this video, I would go max 0.05mm deep.
But when going shallower, you hsould go faster with your feed, i suggest 0.03/0.04mm/tooth and between 100 and 140m/s as cutting speed.