this is extremely helpful, I am trying to get scratches and scuffs out an RM125 swing arm and it has that clean anodizing and I knew it would screw it up and give it these shiny spots but this helps figure out how to remove them. Also what grit sand paper do you recommend for getting out big nicks? I have some on that swing arm I speak of and I plan on following the same process. I also plan on doing doing what you did for the engine cleaning video and using scotch brite and a cross buff pad to make it look nice and new on the engine.
"It's a bit beatup"........ and proceeds to show pic of the bike with not one smudge of grease on it, not one spec of dirt, lookin' soo fresh soo clean like it just came off the damn factory floor! If you call that 'beat up', I wonder wth you would call mine. Jeezus!
Nice video. However I kind smiled when you said it was a "beat up bike" and clutch cover almost looks brand new :)
Ya we have high standards :-) haha--
Sweet tips! when my 20 year old project bike looks factory again, I owe it all to you.
Up until now I’ve only done mechanical stuff to my cr250, bearings, carb, reeds, hoses all that now I’m going to work on appearance! Great video!
Good luck!
Definitely need to do this to my bike.
My left ear loved this video.
this is extremely helpful, I am trying to get scratches and scuffs out an RM125 swing arm and it has that clean anodizing and I knew it would screw it up and give it these shiny spots but this helps figure out how to remove them.
Also what grit sand paper do you recommend for getting out big nicks? I have some on that swing arm I speak of and I plan on following the same process. I also plan on doing doing what you did for the engine cleaning video and using scotch brite and a cross buff pad to make it look nice and new on the engine.
Sir i also have to buy the yz125 2006 used chassis.. so i will share the link ..
Great channel, subscribed.
Thanks i wanna get my 07 crf450 look like brand new again
Such a great bike
You by chance know what air chuck that is?
how do u get hard nicks out of the frame?
Sanding or even a file- some times if too deep just leave them and blend them in. good luck
My cr fame bit scratch up what sand paper do u use
180-200 and then go up to 400 to finish up
@@dirtbiketv1 ok thank u 👍
Get it vapor blasted for $150. Done. Lol.
i liked that chromey look ha
same man its just hard to keep it clean
ho fuck 3 years old comment lol
Beat up?
yea dont look beat up to me lol
"It's a bit beatup"........ and proceeds to show pic of the bike with not one smudge of grease on it, not one spec of dirt, lookin' soo fresh soo clean like it just came off the damn factory floor! If you call that 'beat up', I wonder wth you would call mine. Jeezus!
Beet up wtf??