A lot of Kreg tools are indeed made or plastic as mentioned in other comments, Although I have used my Kreg Tools for years with out complaint, And I might add when i ordered direct from Kreg tools there customer service was first rate So i really don't understand what the negative comments are biased on. I would and will use kreg tool in the future
Agree. Don’t understand the snobbery around plastic sometimes. Easy to clean, lightweight and cheaper to buy. Not everything needs to be made exclusively of metal.
I think Kreg should setup a monthly subscription fee for us and send us a new tool as they come out with them, because we are going to buy it anyway.....lol I love their stuff.
There are offices full of people designing things that nobody needs. The job of most of these tools are already done by off-cuts from off the floor. Free and you can burn them at the end of the job!
2:35 "....holds every work piece securely in place" . Well not exactly. Boards with an angled edge tend to wander unless you take 4 times as long to drill it.
Just think old timers had none of this and turned out great work... cool tools
Right on
A lot of Kreg tools are indeed made or plastic as mentioned in other comments, Although I have used my Kreg Tools for years with out complaint, And I might add when i ordered direct from Kreg tools there customer service was first rate So i really don't understand what the negative comments are biased on. I would and will use kreg tool in the future
Thanks for sharing your experience .
Agree. Don’t understand the snobbery around plastic sometimes. Easy to clean, lightweight and cheaper to buy. Not everything needs to be made exclusively of metal.
I swear! Kreg is going to have me broke!!
Same. Such a great line of products.
I think Kreg should setup a monthly subscription fee for us and send us a new tool as they come out with them, because we are going to buy it anyway.....lol I love their stuff.
Is the panel carrier not a rip off of the gorilla gripper?
Not sure, but it could be better.
There are offices full of people designing things that nobody needs. The job of most of these tools are already done by off-cuts from off the floor. Free and you can burn them at the end of the job!
Good stuff , noting new , noting spectacular, helpful when needed, but narrator sounds like snake oil salesman , I would not buy a screw from him.
noting? Is that like "nothing"?
KREG has turned into K-TELL... now they need to have infomecials at 0200 with the same guy's voice
2:35 "....holds every work piece securely in place" . Well not exactly. Boards with an angled edge tend to wander unless you take 4 times as long to drill it.
Is an metric system available?
Yes available.
Your quick change bit falls apart .Bottom line
I would never use a impact driver with Kreg screws. You will strip the wood like no tomorrow. No need at all.
Thanks for the suggestions.
Looks like Kreg is pulling the pin on Australia😢
why did you think that?
@@tools-zone No one sells anything here anymore
looks cheap and flimsy.
WAY OVER PRICED.......
We think so.
Over priced plastic junk.
Thanks for the information
Cheap plastic!
Thanks for the suggestions.