I have a 2000 suzuki king quad 300 4x4 and I didn't take note of witch direction when I pulled it apart. What direction should it go any info would be greatly appreciated because I don't have a manual and can't find anything on the internet.
I dropped my one way bearing it exploded i got ot back together even replaced the spring cause it was in terrible shape .... Anyway after my new clutch install ... The mistake of dropping that 1 part is preventing my atv from moving lol
I have CForce 500HO. Tried to crank in cold weather (single digits)After 3 quick cranks with no startup the starter stopped cranking the engine. The starter turns fine.. Solenoid and battery good. I hear and feel starter is turning some engine components but again is not cranking engine. Do you suspect one way bearing? If I remove housing and just try to turn clutch assembly and if it spins in both directions then am I safe to say bearing took a crap? It only has 250 miles and is 1.5 years old? Do you know of any other issue or component that may have been affected ? Thank you
Great video watch so many to find out what you put in a great video
Thank you for this video, saved me big time!
Great video. The manual is a little convoluted in its description, this helped me to ensure I was doing it right.
Do I need to tighten the screw with glue?
Hello, with what torque Nm should I tighten the wet clutch in Arctic Cat 450?
Im changing a one way bearing on my 2011 Polaris ranger ranger 900 xp it's the one that's for starting the motter?
I have a 2000 suzuki king quad 300 4x4 and I didn't take note of witch direction when I pulled it apart. What direction should it go any info would be greatly appreciated because I don't have a manual and can't find anything on the internet.
hello ! does the wet clutch make a noise when it is starting to go
How do you take off the wet clutch I can’t find any info anywhere
What happens if the bearing is bad or you take it out?
What if there are chatter marks on the wet clutch shaft
I only wish I had watched this video the first time I put it all back together.
Super
Great video
I dropped my one way bearing it exploded i got ot back together even replaced the spring cause it was in terrible shape .... Anyway after my new clutch install ... The mistake of dropping that 1 part is preventing my atv from moving lol
I have CForce 500HO. Tried to crank in cold weather (single digits)After 3 quick cranks with no startup the starter stopped cranking the engine. The starter turns fine.. Solenoid and battery good. I hear and feel starter is turning some engine components but again is not cranking engine. Do you suspect one way bearing? If I remove housing and just try to turn clutch assembly and if it spins in both directions then am I safe to say bearing took a crap? It only has 250 miles and is 1.5 years old? Do you know of any other issue or component that may have been affected ? Thank you
did u fix this issue?
If the kickstart is loose, is it possible that the one way bearing is not functioning? Or they are both connected in kickstaring?
If the one way bearing is bad itll kick but not actually turn over the motor.
Looks like the same as the Eiger aswell...
Is this a known problem on the massimo
What happens if it’s in backwards?
It slams into gear -
What does it do if u have it on wrong
It slams into gear.
Вот наверное на котах сцепление и брякает...оно в руках издает такой же звук
Why is it a need for a one way bearing
engine braking when you let off the gas