Have you ever use the cn3 connector to use the position mode? Because in a CNC the controller would have only the step/dir signal. So Im wondering how to connect the servos like that. I just purchased 2 of them at 1.5kw.
Hello, I would like your help, I need to do a project. The PLC, an FX3U, will send the MR JE C servo to rotate to one side a certain amount of pulses entered into a register on the Sankoom HMI, when it reaches the count, the servo returns to the value of 0. Could you help me with the pins of the CN3 connector and the configuration parameters in mr2?
Hi, can you tell me what are the differences between the two cables for the servo motor: MR-BKS1CBL5M-A1-H MR-BKS1CBL5M-A2-H What do the symbols A1 or A2 mean?
these channels crack me up. really great for getting devices up and running but the views are always so low. thanks for the help.
US three phase is usually 208V @6:32
Good to know.
Have you ever use the cn3 connector to use the position mode? Because in a CNC the controller would have only the step/dir signal. So Im wondering how to connect the servos like that. I just purchased 2 of them at 1.5kw.
I'm curious about it as well!
I like to learn about servo drivers repair
How about STEP/DIR control - is it possible with these amplifiers?
Hello, I would like your help, I need to do a project. The PLC, an FX3U, will send the MR JE C servo to rotate to one side a certain amount of pulses entered into a register on the Sankoom HMI, when it reaches the count, the servo returns to the value of 0. Could you help me with the pins of the CN3 connector and the configuration parameters in mr2?
How can you program it via the TIA Portal, PROFINET?
Can I use MR Configurator 2 software to connect to a J3 drive?
Yes, but to program positions, you will need fx configurator.
Sir tell me DBR connection in Mitsubishi drive MR-j4-11KB
Hi, how can ı run pul,dir ı have a motions card ı dont know whic pin ı will connect it
3:47 How can I search for that device that distributes power?
Don't understand your question my friend. Can you rephrase it?
@@IGSElectronics I'd like to buy a distributor in the video that connects to L1, L2, L11, L21 ports. What words should I search for?
Hi, can you tell me what are the differences between the two cables for the servo motor:
MR-BKS1CBL5M-A1-H
MR-BKS1CBL5M-A2-H
What do the symbols A1 or A2 mean?
I actually don’t know, sorry. When I next time catch up with Mitsubishi, will ask them.
@@IGSElectronics ok,thank U
Dear sir, Mr-J3-40B display 24, how to fix. Thanks a lot!!!
Did you looked up in manual what it is or connected MR configurator to check what it is or what to do.
Maybe board NG
Ok mane