I have a quick question, when I go to extensions and put in the github address for the DFRobot driver board (I've got v2.0) the only option i have is the microbit robot driver and doesn't contain the df-driver tab you have? Any ideas?
Not sure why it's not working but I've just created a blank project with the extension, maybe see if this works? makecode.microbit.org/S94480-61598-84173-57440
Hello.A question you have mentioned in the video that we can connect the water pump directly on the microbit 3v and GNd. I have done that but I can't stop the pump after 2 sec it works constantly. My extension board doesn't exist on Microsoft makecode.
If the extension board doesn't exist, you could potentially connect your pump to the using the pins. In theory you could use p0 and use the "turn digital pin 0 to 1" block to turn on and conversely to 0 to turn off.
@@theinnovationclassroom thank you very much for your answer! I have think that but the bump haw only to wires one for 3v and one for gnd how can I connect another one that i can use the pin0 if you have some idea
Hi, could you explain again why you set to stop motor first on your code page, followed by Analog write pin0 to 1023 and Analog write pin0 to 0? Thank you for sharing.
What Micro:bit project are you currently working on?
Hey my friend, could you do a video on how to code a microbit for hydroponic ebb and flow systems? thanks, if not all good.
I have a quick question, when I go to extensions and put in the github address for the DFRobot driver board (I've got v2.0) the only option i have is the microbit robot driver and doesn't contain the df-driver tab you have? Any ideas?
Not sure why it's not working but I've just created a blank project with the extension, maybe see if this works?
makecode.microbit.org/S94480-61598-84173-57440
Hello.A question you have mentioned in the video that we can connect the water pump directly on the microbit 3v and GNd. I have done that but I can't stop the pump after 2 sec it works constantly. My extension board doesn't exist on Microsoft makecode.
If the extension board doesn't exist, you could potentially connect your pump to the using the pins. In theory you could use p0 and use the "turn digital pin 0 to 1" block to turn on and conversely to 0 to turn off.
@@theinnovationclassroom thank you very much for your answer! I have think that but the bump haw only to wires one for 3v and one for gnd how can I connect another one that i can use the pin0 if you have some idea
can we use l298n motor driver to turn on the water pump
Hi, could you explain again why you set to stop motor first on your code page, followed by Analog write pin0 to 1023 and Analog write pin0 to 0? Thank you for sharing.
How to add on solar panel into this project
Why do we need the Microsoft surface
It was just the power supply for my microbit in this case.
Dumb question, what is the MS Surface device? Is it taken out of a larger commercial surface device or something else?
It took me a while to realise what the question was! It is simply a branded powerbank!
@@theinnovationclassroom Oooh LOL OK thx