Flamco Flexcontrol: simple checking of expansion vessel pre charge

Поділитися
Вставка
  • Опубліковано 7 гру 2024

КОМЕНТАРІ • 11

  • @slawekcyrwus8395
    @slawekcyrwus8395 3 роки тому

    😂prawie się udało ,ale porusza poważny problem 👏

  • @superwout
    @superwout 3 роки тому +1

    So turn right to isolate and drain, turn left to close drainage and connrct to the system again?
    I remember using one of these valves but there was no manual available at the time...

  • @chaseenginesltd9442
    @chaseenginesltd9442 4 роки тому +2

    It would be useful to know the pre-charge pressure required for a given system pressure

    • @Flamcogroup
      @Flamcogroup  4 роки тому

      pre-charge and selection of vessels can be calculated using our online tool: apps.flamcogroup.com/calculators/central-heating/1/1

  • @eazyrat
    @eazyrat 2 роки тому

    is that balloon analogy the case will vessels then? they will always inevitably lose pressure? thanks

  • @ALARMusII
    @ALARMusII 4 роки тому

    is there a scheme for the operation of this device, which directions opens and which closes in opposite positions ?

  • @cliffhanger906
    @cliffhanger906 Рік тому

    But from the looks of it, since the Expansion vessel is high up, you aren`t completely empyting it out of the water to have an accurate meassurement.
    It might say 0.65 but in reality it could be alot less.

  • @davidnichol6282
    @davidnichol6282 3 роки тому

    Very informative.

  • @SuperCaliListic
    @SuperCaliListic 3 роки тому

    what literally everyone sees: flamco
    what I see: flamingo

    • @spreygawd
      @spreygawd 5 місяців тому

      BRO THATS LEGIT WHAT I SEARCHED FOR YEARS AGO