Great job, nice to see the inner sleeve left longer than the gland base, too many folk cut it right back and you end up with single layer of insulation next to the rough gland inner. That would pass a Chemical plant inspection if it was an E1FW gland. If you use adaptors, the inner sleeve should go past them by at least 10mm though. I think 3 and 4 look a bit short on the inner sleeve.
First cable too long tbh. I would advise not cutting the inner insulation off until after it's in the isolator. This avoids possible scratching of the core insulation. If you score around the inner insulation first before inserting then the inner comes off easier . Good effort though my friend . Spent over 35 years doing swa btw lol 😆
Thanks master.. to share your knowledge..more power master
Thank you for watching
Great job, nice to see the inner sleeve left longer than the gland base, too many folk cut it right back and you end up with single layer of insulation next to the rough gland inner.
That would pass a Chemical plant inspection if it was an E1FW gland.
If you use adaptors, the inner sleeve should go past them by at least 10mm though.
I think 3 and 4 look a bit short on the inner sleeve.
Thanks brother appreciate your suggestion
👍👍👍👍
Nice
😍😍😍
I’d redo the first one get more bend on it
First cable too long tbh. I would advise not cutting the inner insulation off until after it's in the isolator. This avoids possible scratching of the core insulation. If you score around the inner insulation first before inserting then the inner comes off easier . Good effort though my friend . Spent over 35 years doing swa btw lol 😆
Thanks for the advice sir. Stay safe
What is the procedure for cable termination...this video all about how to gland the cable
It depends on what you are going to terminate from LOw voltage to High voltage
Pls use lug
i think this site is in emirates hills 🙂🙂
Good job bosing..Ilan ang FLc mo 35mm ba Yan o 50mm..stay safe God bless
50mm po sir.
THIS CABLES I THINK FOR AIR HANDLING UNITE SUPPLY.
EXACTLY
You should be using CW glands for outside.
Thanks for watching!
That is a CW gland.
It is a double compression gland, CW is specially use for outdoor applications and where necessary to provide an IP66. Regards & thanks for watching
That is a BW gland
Single compression for indoor use
Looks terrible you had loads of on the cables but you fucked the bends up totally.
Thats the customers req😁
Wrong glands and no IP washers used.
Ang hirap gawin hehe
Kaya po yan basta pag aralan lng maigi. Ingat po
Nakakairita Ang ganyang disconnect switch master Lalo na yong selector type. Mag termination ka ng 10mm wire. Masakit sa kamay.
Yes boss tyaga lng hehe, salamat po
Wrong glanding
Thank you sir. Appreciate your comment. Stay safe
No good....!🤭
Dress properly your cable