Thank you for a great instructional video. And thank you for not doing a stupid intro and not having the super annoying background music during your video like so many UA-camrs do.
There is pumps made to check for water every 3mins. If water is detected it runs till the water is out. You can put a switch on it so when it's not in the water you can turn it off
Great Tutorial bro the only problem is if you don't buy the kit ... You can't buy the pump mounting bracket seperately. Any ideas how you could mount the pump ... Without the bracket?
Aluminum L brackets. Tractor supply has a whole selection of things like that. I’m going there maybe I can find a part number or something. Maybe help a few other people out
How did you just get the rear off? I have a bolt that broke when I did the wear ring install and now I have to get to the inside of it to replace the pump support
Yes. U can get the pump and float switch at Walmart. I’m sure Amazon probably has something you can use. I would go that route instead of buying the kit
It always gets a little wet. If you barrel roll it, it gets more wet. And if you ever been on a sinking ship, you would install and test it frequently.
Your sponsons in the lower position will make the back end hook into the water and not drift/spin. If you wanna do tricks and spins don't bother with them or put them in the full up position.
Thank you for a great instructional video. And thank you for not doing a stupid intro and not having the super annoying background music during your video like so many UA-camrs do.
@@imbatman66 or 15 minute vlog for what should of been a 3 minute video
There is pumps made to check for water every 3mins. If water is detected it runs till the water is out. You can put a switch on it so when it's not in the water you can turn it off
do you feel the thru hole is low. seems to be in the water no?
thanks for sharing, any new ideas or tips? I am some to add bilge to my ski
Great Tutorial bro the only problem is if you don't buy the kit ... You can't buy the pump mounting bracket seperately. Any ideas how you could mount the pump ... Without the bracket?
Aluminum L brackets. Tractor supply has a whole selection of things like that. I’m going there maybe I can find a part number or something. Maybe help a few other people out
@@FcDominick Thanks man! 👍
How did you just get the rear off? I have a bolt that broke when I did the wear ring install and now I have to get to the inside of it to replace the pump support
That float switch will be turning the pump on and off when hitting waves
Better than running non stop
Pick what way works best for you
It’s a centrifugal style pump. There is nothing to burn out in the pump.
If the bilge pump has an internal float, it will have 3 wires. One ground, one power for float and one switched power for over-ride.
What free flow exhaust is that?
Wet Jet performance
Too late now, but shoulda installed the Whale Supersub SS1212. No float switch needed.
How did you mount the float switch, made my own kit after watching your video
Where did you get that new float? Also could I just buy similar pump at local store?
Yes. U can get the pump and float switch at Walmart. I’m sure Amazon probably has something you can use. I would go that route instead of buying the kit
Hi mate they are a dry run pum they can run with out water for ever
Why do you need a bilge pump in there? There shouldn’t be any water in there
It always gets a little wet. If you barrel roll it, it gets more wet. And if you ever been on a sinking ship, you would install and test it frequently.
Your sponsons in the lower position will make the back end hook into the water and not drift/spin.
If you wanna do tricks and spins don't bother with them or put them in the full up position.