Jim have followed your setup guide to set the Ver 5.2 in point F Rudder direction. My question comes from the quick setup guide for Ver 5.2 in addition to the steps you have taken there is an additional (optional) step to advance the rudder stick to full deflection and the status light should change from a flashing light to a solid light in both directions. Adjusting the servo throw in the transmitter to 150% will not gain a solid light as described in the manual. Is there any insight you can shed on this problem, Thank you so much this is my first FBL setup and want it to be correct all other settings you show matches with 5.2 manual.
I know this is a old video but I'm having a issue with setting up SRXL to AR8020T to microbeast,, the micro beast doesn't see the receiver, it just flashes the a letter, when I hold or press the menu button it cycles through solid red, solid blue ,off then goes back to solid red and flashing, never goes to menu b or N any help would be great
Hello from Spain but i maked it all with the 470LT M with the Microbeast X 5.1.4 but you tell nothing how to set the Rate and Headlogging mode because i dont understand to set it wright . And the Microbeast have to change the ligts when you set is on his wright place . I hope you can explain it because nobody on You Tube has maked it . I hope you can help me , ihave set it to Mircrobeast and not Tranmitter and my Tranmitter is the Algin A10 with single line receiver on 2 Algin Helis The first was the 450L 3S ARTF so all is setted . Best regards from Alicante Spain :-))))))))))))))))))))))
Thank your for a very good video. I've used it a lot to set up my TRex 700. There are many BestX setup-videos out there. This is the best one.
Jim have followed your setup guide to set the Ver 5.2 in point F Rudder direction. My question comes from the quick setup guide for Ver 5.2 in addition to the steps you have taken there is an additional (optional) step to advance the rudder stick to full deflection and the status light should change from a flashing light to a solid light in both directions. Adjusting the servo throw in the transmitter to 150% will not gain a solid light as described in the manual. Is there any insight you can shed on this problem, Thank you so much this is my first FBL setup and want it to be correct all other settings you show matches with 5.2 manual.
I know this is a old video but I'm having a issue with setting up SRXL to AR8020T to microbeast,, the micro beast doesn't see the receiver, it just flashes the a letter, when I hold or press the menu button it cycles through solid red, solid blue ,off then goes back to solid red and flashing, never goes to menu b or N any help would be great
thanks jim, subbed . i am struggling with my dx9 and sat ..
What battery are you using?
Hello from Spain but i maked it all with the 470LT M with the Microbeast X 5.1.4 but you tell nothing how to set the Rate and Headlogging mode because i dont understand to set it wright . And the Microbeast have to change the ligts when you set is on his wright place . I hope you can explain it because nobody on You Tube has maked it . I hope you can help me , ihave set it to Mircrobeast and not Tranmitter and my Tranmitter is the Algin A10 with single line receiver on 2 Algin Helis The first was the 450L 3S ARTF so all is setted . Best regards from Alicante Spain :-))))))))))))))))))))))