The step-by-step is extremely helpful to people like me, who are new to the 9C (I just got a used non-Super 9CAP). Thanks. For experienced users, or people who want to double-check their settings without going through the video again, here's the setup in writing: Under AUX-CH Set channel 5 to switch C Under ENDPOINTS Set channel 5 to 47 47 Under PROG.MIX1 2/2 MIX>OFF MAS>OFST SLV>5:GEAR LINK>ON SW>D POSI>UP Under PROG.MIX1 1/2 (OFF) (OFST->GEAR->) RATE>- 50%
Excellent video, renotoa. It will be very helpful for APM users with Futaba Tx. I am going to tell my friend to take a look your video. Thanks a lot, renotoa.
I am using a T9CAP pcm 1024 (not a super ) on prog.mix1 2/2 page on mix> I can only get inh or on no off option is available What am I missing? every thing else is right on please respond
You can get a tx battery from Hobby King it is in the NanoTech battery or tx/rx battery section. It is the 2500ma 5c discharge 11.1v transmitter battery. Hope this helps.
Many thanks too from over the water, this is easily the least complicated 6 mode set up that I have found.
The step-by-step is extremely helpful to people like me, who are new to the 9C (I just got a used non-Super 9CAP). Thanks.
For experienced users, or people who want to double-check their settings without going through the video again, here's the setup in writing:
Under AUX-CH
Set channel 5 to switch C
Under ENDPOINTS
Set channel 5 to 47 47
Under PROG.MIX1 2/2
MIX>OFF
MAS>OFST
SLV>5:GEAR
LINK>ON
SW>D
POSI>UP
Under PROG.MIX1 1/2
(OFF)
(OFST->GEAR->)
RATE>- 50%
Many thanks for taking the time to make the video, works a treat for me
Excellent video, renotoa.
It will be very helpful for APM users with Futaba Tx.
I am going to tell my friend to take a look your video.
Thanks a lot, renotoa.
Thanks, works perfect on my Futaba F9CHP, fine explenation
Thank you so much! Was great helpful for me
No problem:) Thank you! I'm glad it helped
I'm trying to set this up on my 9c but I'm using PPM and I'm not sure which switch your talking about in your FYI note.
hi i wanted to know if this radio has failsafe mode ... i can't find it in the menu ... thanks
Is this a good one for a submarine
I am using a T9CAP pcm 1024 (not a super ) on prog.mix1 2/2 page on mix>
I can only get inh or on no off option is available What am I missing? every thing else is right on please respond
it only works in pcm mode
Where can I get that battery for my transmitter I'm still using 9 volts
You can get a tx battery from Hobby King it is in the NanoTech battery or tx/rx battery section. It is the 2500ma 5c discharge 11.1v transmitter battery.
Hope this helps.
oops got it my bad switch positions changed it from on to off good to go thanks
Why do you need 6 mode ?