Це відео не доступне.
Перепрошуємо.
bmw 1 series headlight removal
Вставка
- Опубліковано 23 тра 2018
- How to remove the Bmw 1 series headlight units without taking the whole bumper off.
💡 (Amazon Affiliate Link)
Philips RacingVision +150% H7 headlight bulb 12972RVS2, twin pack amzn.to/2ZQNewd
(Disclaimer) RYTC is a participant in the Amazon Services LLC Associates Program, An Affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to www.amazon.co.uk
Useful video. I'll be repairing a headlight on my 120d soon a d it's good to know the whole bumper doesn't need taking off.
I'm about to take the wing, bumper and that headlight out, so thanx !!
Good video 👌🏾 could you list every tool I’ll need for this by any chance? Thanks in advance
Rick, Is it possible to do the same on a 2009 BMW Series 1?Thanks
What did you say you were fitting? Can't quite make that out. Are you fitting projector headlights? I'm planning to do that too because the aftermarket ones with a H7 fitting just came out. Thanks for the instructive video. I'll need it!
going to try and fit some Hid Lights that Came off my old Corsa and good luck👍
Nice, and thanks!
Hi! Which aftermarket ones are you planning to upgrade to? Thanks
Hello Rick, my daughter just got a 2010 BMW I series, she found out quite fast that BMW has issues with rear window power mechanisms. Cheers Rick
Hi mate, I have been trying to remove my headlights from my 2012 F20 but the two headlight bolts (alignment nuts) at the bottom of the headlights seem impossible to remove as the nut keeps spinning when trying to undo the bolt since the clip over the top doesn't seem to be doing its job by holding the nut in its place. Is there a way round this do you know? Any help would be appreciated.
How did you get round this in end?
@@stevenlangley8618 so, I've just done this change.. those screws were a pain in the ass.
On passenger side, I pulled the retaining clip back and held it with a spanner and unscrewed with other hand. Nice and smooth, drivers side not so smooth.
I made the bad decision of just snapping the old lights off those screws 😂 then hacksawing them off (I ended up stripping them)
Only issue now is I can't find what screws I need to replace them. If you're in the process of this, if you could send me the measurements of the screw I will love you forever.
same problem
Bend away the Metal clamp until you can fit a 10mm wrench on the nut.
Try to bend it with a screwdriver, than use a hammer to drive the wrench on the nut.
Fun fact: the screw i sealed with locktite.
OMG what a p**** in th a** for a just a single headlight remove. Replacing the buld is also som much complicated and almost impossible without doing this. Shame on you BMW.
The same thing just happen to mine, my led light bulb fell inside the light unit. How much would that sort of thing cost to get it out ?
Thanks a lot
wow.....all that to change a headlight.....wonder how much BMW would charge for that headlight replacement
A lot
...and now you can see there is no satisfaction being an BMW owner, a real disaster.....
Most cars are designed this way not just BMW
To be honest it's not complicated as it looks it's just normal maintenance as stated above most cars I like this nowadays Plus anybody can do would a set of minimal tools that are cheap mainly just talk to you and 10 mil sockets the only hard thing you need is a flexi extension for the one T30 torx on the headlight lower mounting bracket the
My wife has one, think we will be selling it, all this for headlight, just crazy
first