hi obias, i would like to use khone optiflux 6050 to control a tank filling of 2700L or 3400L depending on the process on the same tank, thank you very much for your videos i ve learned a lot
sir! krohne 2300c display 1 error " over range" always shown.while in display 2 is correct reading in Analog input 1. it is foundation fieldbus. can y u help me sir.. thank you for sharing your vedio
Thanks for the video, it was very helpful. Can the steam meter be set to display total kg of steam passing through the meter rather than kg/h? I have the meter set to pulse for 1 kg of steam and require the display to match the pulse output.
@@teamobiasvlogs495 Hello and thanks for relying! It's a Optiswirl 4200. I may have found what I'm looking for in the manual. I think I need to change the display measurement from 'Mass flow' to 'Mass'. Setup>Display>Meas. Page>C5.3.2 Measurement 1 Line>Mass.
Very informative video. Such an intellectual creature. From your real friend
The tutorial is very illustrative. Thank you so much!
Wow! Thanks! I hope my video was able to help somehow.
Very good explanation
Thank you for this video it is very helpful.
Sir I changed the unit from kg to liter but the value is too low. Which parameter should I go to change the type of process like fuel oil diesel.
I'm guessing as you change the range then the current output changes ??
hi obias, i would like to use khone optiflux 6050 to control a tank filling of 2700L or 3400L depending on the process on the same tank, thank you very much for your videos i ve learned a lot
I have a problem, there are two kronhe mag flows in my plant, the totalizer value increases without having flow....?why..?
I have a problem with a device, that it does not read until the opening rate of the control valve is 25%? What is the solution?
sir! krohne 2300c display 1 error " over range" always shown.while in display 2 is correct reading in Analog input 1. it is foundation fieldbus. can y u help me sir.. thank you for sharing your vedio
Thanks for the video, it was very helpful.
Can the steam meter be set to display total kg of steam passing through the meter rather than kg/h?
I have the meter set to pulse for 1 kg of steam and require the display to match the pulse output.
Hi! You have the Optisonic unit? Correct?
@@teamobiasvlogs495 Hello and thanks for relying! It's a Optiswirl 4200.
I may have found what I'm looking for in the manual. I think I need to change the display measurement from 'Mass flow' to 'Mass'.
Setup>Display>Meas. Page>C5.3.2 Measurement 1 Line>Mass.
@@moklism6378 no problem. just hit me up here if you have questions. please do subscribe :p
Sir can you share me vedio link for loop test and calibration of krohne optiflex 2200c level transmitter
Thank you for English 🎉🎉
Wonderful
How to return the counter in flow meter korhone
we need a calibration video please
Assalamuwalaikom sir us ko lang po pwedi ilagay sa online flow meter but showing no data
Thanks
Can we set kg/hr unit??
Yes its possible!
I need information of Ifc 300, in spanish please
Bro...Genii DP1620 not connect
Any suggestion
do you have the corrct dtm? for which model
👍
Ours in our company is always showing installation and nothing
it doesn't match what I see in the MI for the MFC400
Sir please give me krohne optimass service password
sorry. this is not something we give... only for service engineers of krohne. ✌
@@teamobiasvlogs495 how can I change max pulse rate?