Lectrotab ALC-1 Auto Leveling Control Calibration Procedure

There are a number of features on the ALC-1 Auto Leveling Control that can be programmed. This video shows you how to makes changes to these programmable features.

[@atillaismail5411]

Hi sir
i have a (( 2000 sea ray 240 sundancer )) and i have the factory trim tab its working good can i remove my trim switch and install this one or i have to change all the unit ?
please let me know so i can buy one .
Thank you

[@lectrotab-electromechanica7101]

To answer that we'd have to know what type and manufacturer your original trim tab system is. You can call us at 804-368-8428 and we can discuss it with you. Thank you!

[@atillaismail5411]

@@lectrotab-electromechanica7101 Thank you sir i will check it when i bring it home from the storage and will call you .

[@jb243wp]

Hi there, I have just purchased one of these auto controllers to fit my existing Lenco tabs.
However, I do have 2 questions regarding the calibration process.
1. Should this calibration be done whilst on the water when the boat is stationary sitting in its natural state, or can it be performed on the trailer?
2. If on the trailer, does the boat need to be sitting somewhere near the same plane as if it was stationary in the water? Or can it be levelled out.
With a full tank of juice at the twin outboards on the back, my boat sits quite arse heavy in the water, just wondering what is the best way to go about this..
Any help would be greatly appreciated, thanks.

[@lectrotab-electromechanica7101]

Calibration can be done on the trailer on in the water, inside or outside. No GPS signal is required for the calibration either. The orientation of the boat is not important for calibration.