An FYI, For a hardtop you will have to compensate for the same 1/4 or 3/16 gap across the top windshield frame and top of doors, also you need to remove the legs off the rear of the hardtop. And as with most broncos then there’s the air/water leaks between the windshield and door weatherstripping to deal with. I run the tail guards with a bikini top, no experience with a soft top install.
Awesome product to be available again. As far as cutting them I always tend to gravitate towards a grinder and a cutoff wheel. So how do I win my set at Supercel is the real question? 🤣🤘
Normally when cutting, I tend to lean towards the cutoff wheel as well, but I thought the sawzall might leave me with a straighter line. As far as the giveaway goes...I have never won anything in a raffle so I am the wrong person to ask😂😂
East coast you have to pivot off trees.. front lasts longer and bolts on. My joke is that the Bronco was Ford’s engineering practice of how little it takes to make a vehicle.
An FYI, For a hardtop you will have to compensate for the same 1/4 or 3/16 gap across the top windshield frame and top of doors, also you need to remove the legs off the rear of the hardtop. And as with most broncos then there’s the air/water leaks between the windshield and door weatherstripping to deal with. I run the tail guards with a bikini top, no experience with a soft top install.
Such a great point and one I totally didn't think of. I'm gonna pin this comment. Thanks for the feedback!
👍
Brass rivets would really look cool!!!! 😎
100%!! It's all up to you!
So happy to these quarter guards make a come back
It's such a great product!
Thanks for the video. The concept of armor plates in general is just cool :P
Definitely! haha thanks for checking them out!
I am excited about these, we need to protect our rigs. They look beefy.
100% They aren't going for $500 rust free anymore hahaha
it seems so nice, we proud of our work. It was a great experience for us to work with you!
I think we did a great job. It seems nice
Awesome product to be available again. As far as cutting them I always tend to gravitate towards a grinder and a cutoff wheel. So how do I win my set at Supercel is the real question? 🤣🤘
Normally when cutting, I tend to lean towards the cutoff wheel as well, but I thought the sawzall might leave me with a straighter line. As far as the giveaway goes...I have never won anything in a raffle so I am the wrong person to ask😂😂
Make sure you tie it to the roll bar that way if you really need the guard you wont push the quarter over.
Not a bad idea!
Now we just need the whole rear side or 1/4 panel!
They should have just made the whole Bronco out of 1/4" steel😂
East coast you have to pivot off trees.. front lasts longer and bolts on. My joke is that the Bronco was Ford’s engineering practice of how little it takes to make a vehicle.
Good stuff my man! How much to preorder?
It costs nothing to preorder. We will charge you when we ship the product to you. Preordering just ensures that there is a set with your name on it.