Hyundai Santa Fe - Repair LEAKING Window Washer Pump
Вставка
- Опубліковано 10 вер 2024
- RELEVANT LINKS:
To purchase replacement pumps, purchase links here:
1. amzn.to/4cQYaen (angled plug)
2. amzn.to/4aIB6MZ (straight plug - also fits)
**This site contains affiliate links for which I may be compensated.
WANT TO SUPPORT ME? My videos are free to watch, but are not free to make. If you enjoy my content and want to support my work - I am very grateful. Here's the link: ko-fi.com/jelb...
#fixleak #diy #hyundai
Great video, I don't have a 3D printer so I just bought the part...the instructions were great but when I installed the new pump it did not work at first. I had to prime the pump by pulling off the two outflow lines and letting it bleed for a little bit. After replacing the tubes back on the pump it worked perfectly. Thanks for posting this video.
Most welcome.... glad it was helpful. That's good advice about bleeding trhe line a bit! :)
@@jelreviews which one did u get? the 2 I ordered were rubbish weak as piss.
@@TrevEvans Yeah, I didn't order any because I repaired mine with the 3D printer component and it worked. However, I put the links to the two pumps that would fit into the description of the video. Check them out and see if it would suit yours.
Was rooting way too hard for you on this. Felt like we won the championship at the end.
Good video
My 2017 broke in the exact same place! Thanks for the video, great job!!
Nice work!! Very well done!
As cool as that was, I'm wondering if some shrink-fit like used on wiring wouldn't have done it. I was actually hoping the leak was in the tank; trying to figure out what's holding it from the top...
I Have been Doing Nothing But Car Repairs On My Sons Car And Wife's Car. Maybe Yo Could Hit The Junk Yards and Get A Used 1. I have been Teaching My Son How To Go To Junk Yards And get parts Way Cheaper. you Could Have Put Some Silicone Also.
That's great teaching your son! Yeah, I could have sourced these parts from the wreckers, but I definitely am enjoying seeing what I can do with 3d printing 👌
What are the specs of the piece you printed. I have that same crack.
Hmm, from memory it was simply a 10mm diameter opening that I made 1mm thick, and around 15 long with a tapered end. I just measured the outlet with my callipers and it was a perfect fit first go.
Mine just broke
Im on my 2nd replacement pump! One from Amazon- the pump was real weak hardly pushing enough water out. Sent that back tried one from ebay after being reassured it works. same garbage as the other except now I gotta pay to send this piece of shit back! Grrrr if only I had 3d printer! here is the crap one.. ua-cam.com/users/shortsh0yiXECWoZ4?feature=share