Розмір відео: 1280 X 720853 X 480640 X 360
Показувати елементи керування програвачем
Автоматичне відтворення
Автоповтор
See a lot of wrongs here. Moving on.
do you use a sherline lathe?
Is that stainless steel?
Just 6061 aluminum. I use aluminum in most of my tutorial videos because it is low cost and very beginning for learning on. I have done some steel and brass on video... don't think I've used stainless steel in any videos yet.
I see you unconventionally face cut from center outwards. why do you prefer this?
Too bad this channel is off line: I was wondering about that also.
That machine is just too flimsy.
So much wrong with this video
See a lot of wrongs here. Moving on.
do you use a sherline lathe?
Is that stainless steel?
Just 6061 aluminum. I use aluminum in most of my tutorial videos because it is low cost and very beginning for learning on. I have done some steel and brass on video... don't think I've used stainless steel in any videos yet.
I see you unconventionally face cut from center outwards. why do you prefer this?
Too bad this channel is off line: I was wondering about that also.
That machine is just too flimsy.
So much wrong with this video