How to Make IR Proximity Sensor using LM358 at Home by Inventive Technical Support
Вставка
- Опубліковано 6 вер 2024
- I have made a project which is IR Proximity Sensor using LM358 IC. I will upload a video soon which is How to Test IR LED & IR Receiver. Please SUBSCRIBE to my channel for more information about Electronics Project.
This circuit can be easily made at home. You can made it too. It take some component to make it which I used.
1. LM358 IC
2. 10K Preset
3. 10K Resistor
4. 330 Ohm resistor
5. IR LED
6. IR Receiver
7. Output LED (5mm Green)
8. Bradeboard
9. Some Jumper Wire
Circuit Diagram : drive.google.c...
Please SUBSCRIBE to my Channel (INVENTIVE TECHNICAL DUPPORT)
and follow me into my social accounts given bilow.
Thanks for watching this Video.
Facebook : / pallab.sarka. .
Instagram : / _its_015
Song: Erik Lund - Summertime (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link: • Video
I'm going to make line follower IR for robot car.
So output from LM358 to that green LED can also be connected A0 pin of Arduino right?
Yes.
@@its015 Thank you for replying.
Do you have tutorial for water level indicator using RF433 and ht12e and ht12d ic?
I able to make it buzzer goes off when water reach highest level but not lowest level.
I'm using only one buzzer for the circuit to save space on my zero pcb.
OK, I'll Try.
🌹🌹🌹♥️👍
Thank you
Ir transmitter and receiver or
Ir receiver and ir led
Which one
in my case Black one is IR Transmitter And White one is IR Receiver.
you 1st Check which is IR LED and Which is IR receiver .
you take a Multimeater and check with Continuty mood. IR LED (Transmiter) Anode Pin Connect to Multimeater Positive Probe and Cathode is connect to Multimeater Negative probe. It showing value approx 1100 - 1200.
@@its015 thank you brother
iam doing this proximity circuit for last 3 weak and didn't got the output i watched almost all videos in you tube about proximity circuits and now watching yours this videos is my last hope
@@themaster6377 you are welcome 😍😍
@@its015 Sir, i have a doubt regarding proximity sensor circuit. That is the circuit connection i have done is correct, but while sensing an object the led is getting OFF and while the object is not in the proximity, the led is getting ON. This is happening exactly the opposite as yours result.
Do you know any Solution to correct it
@@themaster6377 You will connect your Output LED's Cathode pin to IC pin 1 and Anode pin connect to VCC by a 330 ohm resistor
Mr tipe ir rec.....?
Iam indonesia
LED tipe ir rec..
How I check it is white led or ir receiver.... Please reply it is urgent... Please help...
You take a Multimeater and check with Continuty mod. IR LED's Anode Pin Connect to Multimeater Posetive Probe and Cathode is connect to Multimeater Negative probe. It showing value approx 1100 - 1200.
If its an IR Receiver it will show novalue on multimeater.
But if its a White LED it will glow.
@@its015 thank you bro 🙏🙏🙏
@@tanmoyjana205 welcome