Розмір відео: 1280 X 720853 X 480640 X 360
Показувати елементи керування програвачем
Автоматичне відтворення
Автоповтор
Wouldn't it have been easier to make templates and route out the parts?
Sounds good... i do it on that way because i want to use the middle axis of the pulley as the turning axis for milling ✌🏻
Entertaining, but waaaaaaaaay overkill.Try this: Thread the blank on a bolt, chuck it up in a drill, hold it horizontally over a spinning router that has a round bit. (It'll even work if you do it over a sawblade. Won't be as repeatable, of course)
Overkill is the way we design things in germany 🤣 Thanks for your tip 👌🏻
@@craftandconstruction3359 Ha! Fair enough.I have a German uncle who would agree :)
@@timffoster Vorsprung durch Overkill oder was...:)
Wouldn't it have been easier to make templates and route out the parts?
Sounds good... i do it on that way because i want to use the middle axis of the pulley as the turning axis for milling ✌🏻
Entertaining, but waaaaaaaaay overkill.
Try this: Thread the blank on a bolt, chuck it up in a drill, hold it horizontally over a spinning router that has a round bit. (It'll even work if you do it over a sawblade. Won't be as repeatable, of course)
Overkill is the way we design things in germany 🤣 Thanks for your tip 👌🏻
@@craftandconstruction3359 Ha! Fair enough.
I have a German uncle who would agree :)
@@timffoster Vorsprung durch Overkill oder was...:)