How to factory reset a PIX-LINK 2.4GHz WiFi Extender

How to factory reset a pixlink 2.4GHZ Wireless Repeater AP Access Point.
Shows you how to set the defaults in case you have lost or forgotten the IP address or password for the device.

[@dilipgoup9823]

thanks

[@freename]

Thank you for taking the time to leave a comment :)

[@PondKoiTipsTricks]

A question on my new 3 router it goes up to 180mhz with 10 channels at 20mhz it has multi channes what differance does 180mhz do. ?

[@freename]

This is a pixlink WiFi extender?

[@PondKoiTipsTricks]

@@freename yes I was on about the review you did on the 3 router where you said you had 20 and 40 mhz for some reason mine goes up to 180mhz

[@PondKoiTipsTricks]

Huawei

[@freename]

Ok, confusing why your posting on this video. 5GHz WiFi only goes up to 160MHz wide. Are you sure you are looking at WiFi settings and not the 5G cell / wan side settings?

[@PondKoiTipsTricks]

@@freename you are right its 160mhz so what does it mean is 160mhz better than 40mhz its wifi settings 5ghz wifi i was with virgin and paying through the nose but as im 72 years of age i got a deal with 3 for £12 a month unlimited data im in northumberland and my router says connected to quickline communications leeds and im getting strange speeds 960.53 and 105.44

[@titotits]

Saved my life. Thx a lot

[@Vowbreaking]

Lovely accent.

[@freename]

Thank you :D

[@Vowbreaking]

@@freename my repeater works after i complete the set up for it, and when i change its place it shuts off the network and the signal disappeares until i rest it again and loop goes.

[@freename]

@@Vowbreaking It works in both place or only works in one place? If it works in both places but forgets the settings when you turn it off or unplug it, it's probably got faulty internal memory and there's not going to be much you can do to fix that.