Snapmaker J1 Unpacking and Calibration HD 1080p

Snapmaker J1 unpacking and calibration video (fast)
Product: shop.snapmaker...
Please let me know in the comments what I should print next!
Music:
1. Vindicated by Ethan Meixsell
2. Dead drop
Dead Drop by Kevin MacLeod is licensed under a Creative Commons Attribution 4.0 license. creativecommon... incompetech.com... Artist: incompetech.com/
3. Start Your Engines by Ethan Meixsell

[@RouzAstro]

My ears still hurt after that music

[@MakerUrge]

haha. next time so Swiss Country Jodeling :-)

[@BestBananalord]

What kind of material are you using to print? PEI has great adhesion and sometimes too much so its odd that it didn't stick with what I'm assuming is PLA

[@BestBananalord]

Maybe wipe the bed with Isopropyl alchohol before printing next time and see if it adheres better

[@MakerUrge]

Yes, you are right. First prints were PLA, I will do some using PVA as water soluble support material in the next video.

[@MakerUrge]

@@BestBananalord thanks, I tried isopropanol cleaning without improving. Glue stick works very reliable for PLA especially after several prints.

[@NechaevDmitry]

I have pre-ordered one and it is surprising that it does not stick to the new bed, usually it will be sticking as hell.

[@MakerUrge]

Maybe my first layer temperature was too low.

[@wagzprintz]

Is your z height adjustable during printing?

[@soarpix3533]

Great video! What is the maximum print speed and what speed do you print at to get good quality?

[@MakerUrge]

Didnt find the limit yet. Within the specs it works fine.

[@kamb4400]

Hey, can this 3d printer print with a tolerance of +or- .1mm?

[@MakerUrge]

I will try the limits, thanks

[@thedinoman7828]

The music was a pain to hear...

[@MakerUrge]

Sorry, to hear....

[@Todestelzer]

I muted the video 😂